ZKHSS1 for 1/4" Panels
Tubular Stainless Steel Handles
Step 2:
Match
Handle Extrusions to Handle
FOR CUSTOM
WOOD
PANELS
See Step 2A for Stainless Steel panels
•Cut a piece of corrugated to use as a pad to protect the panel finish. Use 1/2" thick section of plywood to protect flooring when drilling.
•Place custom panels on the pad, appearance side down.
Note: If panels are wood, be sure to note which end is the top so that wood grain is in the correct direction on both (or all 3) panels.
•On the back side of the panel – at the handle side, measure and mark 1/4" below the top edge of the panel with a pencil.
•Slip panels into new extrusion on the handle side of the panels.
•Align the extrusion at the pencil mark, 1/4" below the top of the panel.
•Follow the same procedure on the opposite panel.
•Tape the extrusions to the panels to prevent move- ment.
•Center punch and drill 1/8" pilot holes through the holes in the extrusion and into the panel.
•Turn panel over. On the appearance side, use 9/32" bit to enlarge clearance hole.
IMPORTANT: Hole locations must be exact to accept handle standoff and handle assembly.
For models with full width dispenser trim and 2 piece freezer panels:
•Measure 1/4" from the top of the upper panel and 1/4" from the bottom of the lower panel. Mark with pencil on the back handle side.
•Align the extrusion on the pencil mark as shown, top and bottom.
Freezer
Upper
Panel
Back
Side
Freezer
Lower
Panel
Models
With Full Width
Dispenser Trim
Top | Note: Be sure to orient |
End | extrusions and handles |
| correctly. The top ends of the |
| extrusions are cutout to fit the |
| shape of the top of the door. |
| Align Extrusion |
| 1/4" Below Top |
| of Panel |
| Back |
| Side |
| Fresh |
| Food |
| Panel |
Back |
|
Side |
|
Freezer |
|
Panel |
|
Freezer | Fresh Food |
Extrusion | Extrusion |
ZKHSS1
INSTALLATION
Extrusion
Decorator
Door 
Panel
39
