GE Monogram ZIS42N, ZISB42D ZKHT1 Trim Kit For 3/4 Panels, Support for Custom Handles, 1-13/16

ZKHT1 Trim Kit (For 3/4" Panels)

Support for Custom Handles

Option 1 Installation

OPTION 2		1-13/16"			1-13/16"
For dispenser	Note: Optimal final		1/4" Max.
model using	appearance depends on careful	Back Side			Back Side
full-width	routing depth. Do not exceed
trim	1⁄4" routing depth.	Handle Side		Handle Side
Before		Freezer Panel			Fresh Food Panel

you begin

All 3 custom door panels must be routed to accommo- date the door extrusions. Route the panels as illustrated, max. 1/4" deep, 1-13/16" wide, top to bottom on the handle side.

Refer to installation instructions for ZKT42 trim kit, Option 2.

•Follow Step No. 1 to remove standard aluminum trim.

•Follow Step No. 2 and 3 to attach new 3/4" trim pieces and install panel support brackets.

Step 1

Locate position of handle

Note: The custom handle must be installed against the handle bracket. The custom handle cannot exceed 11-3/4" length.

INSTALLATION

ZKHT1

Temporarily Temporarily

Secure Secure

Handle Dispenser

Bracket Trim

With With

Screws Screws

•Position the handle bracket onto the steel door by matching existing screw holes on the door and bracket.

•Re-install dispenser trim, temporarily.

•Determine the desired location of the custom handle and carefully mark centerlines of the screw holes.

•Drill 1⁄16" pilot hole through the trim until it starts

into the handle bracket. This marks the same location onto the bracket.

•Remove dispenser trim and bracket.

36