
ZKHSS1 for 1/4" Panels
Tubular Stainless Steel Handles
This kit provides for the installation of Stainless Steel custom handles on 1/4" thick decorator door panels. The door extru- sions allow these custom handles to be secured to the door structure, rather than to the custom panels. This kit contains all the necessary parts for dispenser and
Tools and materials required:
•#2 Phillips screwdriver
•Drill and 1/8", 9/32" bits
•Custom door panels
•Safety glasses
•Center punch
•Masking tape
•Hammer
•Pencil
•1/2" thick 12" x 12" min. piece of plywood to protect floor when drilling
•For stainless steel panels wear gloves to protect against sharp edges.
Parts List:
A. Fresh food door extrusion B. Freezer door extrusion
C. 2 Stainless tubular handles
D. 10 Spacer rings (for Stainless panels ONLY) (8 required, 2 extra)
E. 8 Handle standoffs
F. 10 Screws for mounting handle standoffs (8 required, 2 extra)
G. 10 Set screws (8 required, 2 extra) H. 3/32" Allen wrench for set screws
Note: It is best that 2 people install this kit.
A |
B |
C |
D |
E |
F |
G |
H |
ZKHSS1 INSTALLATION
Step 1: | • Open doors to 90°. Remove the screws from the full- | |||||
Remove | length handles of both doors. | |||||
Handles | • Retain screws, discard handles. | |||||
| • Locate the 2" x 2" adhesive foam pads packed with | |||||
| the refrigerator. Apply pads to the doors as shown. | |||||
| Corner pads should be as close to inside corners as | |||||
| possible. | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Note: If a custom collar is to be used, order ZWCD1 Trim Kit for 42" and 42" wide models. Order ZWCD2 for 48" wide models.
38