GE Monogram ZISW42D ZG2 Trim Kit, Grille Panel Frame Adjustment, To change grille panel size

ZG2 Trim Kit

Grille Panel Frame Adjustment

ZG2 INSTALLATION

FOR 83", 83-1/2"

AND 84-1/2"

INSTALLATION

HEIGHTS

•This kit provides optional side trim pieces for the original grille frame to fit 83", 83-1/2" or 84-1/2" installation heights.

To change grille panel size:

•Determine the installation height by measuring the enclosure from the floor to the underside of soffit. When there is no soffit, measure to the top of adjacent cabinets.

•Adjust refrigerator case trim to desired height. See Product Installation.

•Select the side trim pieces for your installation height.

Installation	Panel	Side Trim	Panel
Height	Width	Lengths	Height
83"	41"	8-1/4"	8"
83-1/2"	41"	8-3/4"	8-1/2"
84-1/2"	41"	9-3/4"	9-1/2"

Barrel	Discard
Nuts
	Side Trim
	Pieces

E.Mount the assembled panel by dropping into slots on the case trim.

1-1/2" min. gap

A.Locate original grille panel frame supplied with the refrigerator.

•Remove 8 screws (two on each corner) as illustrated. Discard original side trim pieces.

B. Select correct size of side trim pieces (3 sets provided).

•Secure new side trim pieces to original bottom trim.

Important: Maintain 1-1/2" min. gap between top of doors and bottom of grille panel.

Note: ZG1 Grille Panel Kit is available for models produced before January 1997. Panel sizes for ZG1 and ZG2 are the same. The ZG1 kit can be ordered from your Monogram dealer.

C.Remove barrel nuts from original side trim pieces (2 each side).

•Re-install the barrel nuts on the new side trim pieces you have selected.

D. Slide custom panel into front slots.

•Secure the top trim piece to the frame with “L” brackets and screws.

26