GE Monogram ZISB42D, ZISW42D installation instructions ZIS42N non-dispenser

Custom Panel Dimensions

42" Built-In Refrigerator

Custom Door Panel Dimensions Using Standard Trim

ZIS42N (non-dispenser)

1/4" thick panels

or

Standard Trim with 1/4" Panels

Panels secured to 1/4" thick backing

•

1/4" Panels: Cut panels to size.

•

Custom handles with 1/4" door panels require Trim Kit

Freezer Panel

Fresh Food Panel

ZKH1 (or ZKHSS1 for tubular-stainless steel handles).

Standard Trim with Panels secured to

1/4" thick backing

•

Applying a raised panel design to a 1/4" thick backing

(screwed or glued): Cut 1/4" panels to size, fabricate the

raised panel to permit clearances of at least 2" from the

handle side for fingertip clearance of the standard

handle, 1-1/4" from the hinge side to avoid striking

67 7/8"

adjacent cabinetry and 5/16" from the top and bottom

edges to allow for the trim flange then install.

•

Countertops adjacent to refrigerator installation should

be mitered 45° degrees.

Note: ZKHT1 custom handle kit cannot be used in this

configuration.

Custom Grille Panel

15 1/4"

25 1/4"

41"

Important: Maximum weight for fresh food panels is

9"

1/4" Thick Panel

50 pounds and 30 pounds for freezer door panels.

Raised Panel on 1/4" Thick Backing

The grille panel frame is factory assembled

for 84" installation height. If installation height

Using Standard Handles

varies, order ZG2 trim kit which provides

optional side trim pieces. Cut grille panel to

sizes shown below.

1/4"

Thick

Appearance

Installation Height

Panel Height

Backing

Panel

83"

8"

83-1/2"

8-1/2"

1 1/4"

2" Clearance

84-1/2"

9-1/2"

Clearance

Important: Maintain 1-1/2" min. gap between

handle side

hinge side

top of doors and bottom of panel frame.

Case Trim

Door

Handle

CUSTOM PANEL DIMENSIONS

7