Enviro EG31-118 Initial Installation, Minimum fireplace size Width 34 86.36 cm Height 21 53.3 cm

Initial Installation

WARNING: Operation of this heater when not connected to a properly installed and maintained venting system can result in carbon monoxide (CO) poisoning and possible death.

Warning: Failure to position the parts in accordance with this manual, or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.

CLEARANCES TO COMBUSTIBLES:

Mantle pillar to glass door	9” (22.8 cm)
From floor to 8” wide mantle	38”	(96.5 cm)
Minimum non-combustible surface in front of unit	11”	(27.9 cm)

Warning: Clearances must be sufficient to allow access for operation, maintenance and service. Stove must sit on a non-combustible surface.

Depth of unit into fireplace 16” (41 cm) Depth of unit out of fireplace 3’’ (7.6 cm)

Minimum fireplace size: Width 34” (86.36 cm) Height 21” (53.3 cm)

Depth 18” (45.7 cm)

BVENT MODEL:

WARNING: This appliance has been designed to operate by drawing combustion air and dilution air from the room. It is also designed to draw room air for proper heat circulation from the sides of the unit. Blocking or modifying the louvers in any way can create hazardous situations, either through poor venting or by overheating. It is important that this unit has sufficient air circulation for proper venting and combustion. Provisions must be made for the supply of adequate combustion and ventilation air. These openings must not be blocked. The appliance must not be connected to a chimney flue servicing a separate solid fuel burning appliance.

AUTOMATIC FLUE GAS SPILL SWITCH:

NOTE: This heater must be properly connected to a venting system. This heater is equipped with a vent safety shutoff system designed to protect against improper venting of combustion products. This safety switch is located on the rear of the appliance close to the draft hood relief opening. If the switch trips more than once, the venting should be inspected by a qualified service technician for possible blockage or severe down draft conditions.

BV Only: The draft hood must be in the same pressure zone as the air inlet. To inspect draft from
the front of the unit, locate the 1⁄4” tube between
the louvers (see Figure 13) and check for a draft
using smoke. A vacuum or suction into the tube will		Check draft
indicate proper drafting.
		with a match
This model can be vented with 4” aluminum or		or smoke in
stainless steel flex vent and/or certified Type B Gas		a 1⁄4" (6 mm)
		tube located
Vent. The flue collar of the appliance will fit inside
		here.
of a standard 4” vent and may be fastened directly
to the vent, check periodically that the vent is
unrestricted and an adequate draft is present when
	Figure 13: Draft Check.
the unit is in operation.

12