ZKHSS1 for 1/4" Panels
Tubular Stainless Steel Handles
Step 2A:
FOR
STAINLESS
STEEL
PANELS
If you are installing these handles onto Stainless Steel panels:
Use extreme caution if you are drilling through stainless steel panels. Stainless panels must be handled gently. Do not kneel on stainless steel panels. It will leave a permanent dent. Do not remove protec- tive plastic covering until final installation.
•Place supplied filler panel (corrugated) on floor to use as a pad.
•On the back side of the
For models with full width dispenser trim and 2-piece freezer panels:
–Measure and mark 1/4" below the top edge of the upper panel.
–Measure and mark 1/4" above bottom edge of lower panel.
•Slip panels into the new extrusion, flush against inner edge, on the handle side.
•Align extrusion to pencil mark(s) as shown in Step 2. Mark each screw hole location with pencil.
•Tape extrusions to panels to prevent movement.
•Place panel on plywood section, appearance side down. Be sure plywood is clean without nicks and burrs. Center punch at each screw hole location.
•Drill 1/8" pilot hole. Use 9/32" bit to enlarge clearance hole.
•Measure and cut a 2" wide strip, top to bottom off the corrugated panels. This will allow room for spacer rings between the stainless panel and extrusion.
Step 3:
Install Standoffs onto Handles
Step 4: Install Handles and Panels
ZKHSS1 INSTALLATION |
| |
FOR CUSTOM | ||
| ||
| WOOD | |
| PANELS | |
|
| |
| See Step 4A | |
| for Stainless | |
| Steel panels |
•Place a handle standoff on each attachment post along the handle. Position the set screw hole on each standoff to point to the floor.
•Install set screws into the bottom of each standoff,
using the Allen wrench provided. The standoff should | Screw |
be tight against the handle. | Allen Wrench |
|
Door
Handle
Screw
Decorator
Door Panel
Handle
•Press foam pads against steel doors to temporarily reduce thickness.
•Slide panels into the door trim. Leave about 4" of the panel exposed to allow room to install the handle extrusion.
•Place extrusion onto back side of panel, install mounting screws through the extrusion and the custom panel.
•Screw handle to panel, starting at the top. Moving down the handle, drive each screw partially into the standoff, alternating back to the top until the handle is tight against the panel.
•Slide the assembly into the door frame until the extrusion fits firmly against the steel door.
•Reinstall original screws into the door extrusion.
40
