GE Monogram ZIS42N, ZISB42D To install 1/4 door panels, Step Roll Refrigerator Into Opening

Step 4

Roll Refrigerator

Into Opening

Installation

42" Built-In Refrigerator

•Gently push refrigerator into opening with hands against front corners. The cardboard protective pad should be beneath the refrigerator.

•Roll refrigerator into the opening until it is flush with adjacent cabinets.

PRODUCT INSTALLATION

Step 5

Level

Refrigerator

All models have 4-point leveling. The front is supported by leveling legs, the rear is supported by wheels.

•To level the back of the refrigerator, turn the 7/16" hex nut located above the front wheels. Turn to raise or lower the refrigerator.

•For front leveling, use a 1-1/2" open-end wrench.

•Adjust carefully, the refrigerator should be level and plumb with cabinetry, and should align with toekick height.

Hex Nut Adjusts	Leveling Leg
Rear Wheels

Step 6

Install

1/4" Door

Panels

If you are using 3/4" thick custom panels, SKIP THIS STEP. See Custom Panel Dimensions pages for panel sizes with ZKT42 trim kit and other kits. Refer to trim kit installation instructions in this booklet.

If you are using the custom collar dispenser trim, order ZWCD1 trim kit.

To install 1/4" door panels:

•Open door to 90° stop. Remove the Phillips head screws from the

aluminum trim door handles. Retain all screws.

• Slide panel into the door trim.

• Replace door handles and secure with original screws.

•Again, check to be sure unit is level and that panels align with cabinetry. Doors will not close properly if unit is not level.

•Check for noises caused by incomplete alignment (rubbing of panels, trim or screws).

•Attach 2" x 2" adhesive backed foam pads to the door. These fillers are shipped with literature package in snack pan.

18