Panasonic SC-PT 250 Placement of speakers, Setup example, Getting Started English, Main unit

Page 7
 Placement of speakers

Setup example Placement of speakers

Setup example

Place the front, center, and surround speakers at approximately the same distance from the seating position. The angles in the diagram are approximate.

1

2

3

FRONT

SURROUND

CENTER

(L, R)

(L, R)

 

Main unit

4

SUBWOOFER

GETTING STARTED ENGLISH

Use only supplied speakers

Using other speakers can damage the unit, and sound quality will be negatively affected.

Place speakers on fl at secure bases. Take proper precautions to prevent the speakers from falling if you cannot set them up on an even surface.

Placing speakers too close to fl oors, walls, and corners can result in excessive bass. Cover walls and windows with thick curtains.

Main unit

Keep your speakers at least 10 mm away from the system for proper ventilation.

To allow for proper ventilation and to maintain good

airfl ow around the main unit, position it with at least 5 cm of space on all sides.

Do not block the ventilation holes of the main unit.

CAUTION!

 

 

 

• Do not stand on the

• Refrain from holding the

base. Be cautious when

speaker’s net.

children are near.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Center speaker

Vibration caused by the center speaker can disrupt the picture if it is placed directly on the television. Put the center speaker on a rack or shelf.

To prevent the speakers from falling, do not place directly on top of the television.

Subwoofer

Place to the right or left of the television, on the fl oor or a sturdy shelf so that it will not cause vibration. Leave a space of 30 cm from the television.

Note

You can damage your speakers and shorten their useful life if you play sound at high levels over extended periods.

Reduce the volume in the following cases to avoid damage:

When playing distorted sound.

When the speakers are reverberating due to a record player, a microphone (except For Continental Europe ), noise from FM broadcasts, or continuous signals from an oscillator, test disc, or electronic instrument.

When adjusting the sound quality.

When turning the unit on or off.

If irregular coloring occurs on your television

The front and center speakers are designed to be used close to a television, but the picture may be affected with some televisions and setup combinations.

If this occurs, turn the television off for about 30 minutes.

The television’s demagnetizing function should correct the problem. If it persists, move the speakers further away from the television.

Caution

The main unit and supplied speakers are to be used only as indicated in this setup. Failure to do so may lead to damage to the amplifier and/or the speakers, and may result in the risk of fire. Consult a qualified service person if damage has occurred or if you experience a sudden change in performance.

Do not attempt to attach these speakers to walls using methods other than those described in this manual.

RQTX0055

7

RQT8043

Image 7
Contents Operating Instructions Model No. SC-PT250E GCSGCTGCGS RQTX0055-1BSystem Caution for AC Mains LeadThank you for purchasing this product GETTING STARTED ENGLISHRQT8043 ENGLISHGETTING STARTED RQTX0055Voltage Safety precautionsPlacement ServiceOTHER OPERATIONS Table of contentsGETTING STARTED DISC OPERATIONS2 Remote control batteries AccessoriesPreparing the remote control 1 Remote controlUse only supplied speakers Placement of speakersSetup example GETTING STARTED ENGLISH2 Front speakers Speaker assemblyGETTING STARTED ENGLISH PreparationAttaching to a wall Speaker installation optionsENGLISH Preventing the speakers from fallingConnect to the antenna Simple setupConnect to the power supply Making the connectionsTelevision with SCART terminal Connect to the various television terminalsUsing the SCART AV terminal Using the COMPONENT VIDEO OUT terminals4 Follow the messages and make the setting Performing QUICK SETUP2 Select “DVD/ CD” 1 Switch on the main unit 3 Shows the QUICK SETUP screenVideo systems Disc informationDiscs that can be played Commercial discsAC supply indicator AC IN Overview of controlsMain unit Standby/on switch y/IEXT-IN USB 33, AV 2 34, AUX 32, MUSIC P Remote controlTo cancel DVD DVD/CD FMDisc - Basic play Using the main unit 1 Power on4 Adjust the volume and start playback Using the remote controlStop ENGLISHSearch during play ENGLISH Advanced playDisplaying current playback condition Program and Random play3 To start play from the selected content Playing data discs using navigation menusPlaying data discs Playing RAM and DVD-R/-RW DVD-VRdiscs1 Display the functions Using on-screenmenus3 Make the settings 2 Select the itemS P E ED Functions menu continuedDISC OPERATIONS ENGLISH 1 ENGNORMAL Using on-screenmenus continuedFunctions menu continued DISC OPERATIONS ENGLISH2 Select the tab Changing the player settings4 Make the settings 1 Display the MAIN menu“AUDIO” tab Changing the player settings continuedMAIN menu continued “VIDEO” tabTo exit the setup Changing the delay time of the speakersTo enter the speaker setting Effective when playing multi-channelaudioTo clean discs Tips for making data discsChanging the player settings continued Disc handling precautionsDisplay the unit’s registration code About DivX VOD contentDISC OPERATIONS ENGLISH Automatic presetting Using the radioManual tuning Selecting the preset channelsEnhancing the stereo sound Super Surround Using sound effectsAdjusting the amount of bass Subwoofer level Enhancing the stereo sound Dolby Pro Logic2 Connect the microphone to the jack Using sound effects continued1 Lower the microphone volume to “MIN” Enjoying karaokeAdding an echo effect Mic volume adjustmentVocal cancel function Enjoying karaoke with other sourcesOptional antenna connection Operating other equipment2 To select “MUSIC P.” Optional USB connection and operation3 Adjust the volume of the main unit PreparationTo switch the television’s video input mode Changing the main unit and remote controlOperating the television To switch the television on or offswitched to the standby mode Troubleshooting guidePower No power“ERROR” Troubleshooting guide continuedWhen playing PAL disc, picture “OVER CURRENT ERROR”Television displays Language code list“ERROR” The USB drive or its contents cannot be readDolby Digital GlossaryDecoder DivXPMPO output power SpecificationsRMS Output Power Dolby Digital Mode RMS Output Power Dolby Digital ModeInput power IEC MaintenanceSpecifications continued USB port power