■Preventing the speakers from falling
•You will need to obtain the appropriate screw eyes to match the walls or pillars to which they are going to be fastened.
•Consult a qualifi ed housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
String (not included) Thread from the wall to the speaker and tie tightly.
Approx. 150 mm
Rear of the speaker | Screw eye |
| (not included) Wall |
ENGLISH
Speaker installation options
STARTED
■Attaching to a wall
You can attach all of the speakers (except subwoofer) to a wall.
•The wall or pillar on which the speakers are to be attached should be capable of supporting 10 k per screw. Consult a qualifi ed building contractor when attaching the speakers to a wall. Improper attachment may result in damage to the wall and speakers.
•When mounting the front speakers to a wall, we recommend using a string (not included) to prevent it from falling.
2 Screws | 2 Cover plates |
Preparation for front speakers
1 Remove the speaker cable from the stand.
1Release the cable from the groove.
2
2 Connect the cable (\ page 8).
3 Fit the speaker securely onto the screw(s) with the hole(s).
Front speaker | Center speaker |
106 mm |
|
| 200 mm |
340 mm |
|
| Surround speaker |
Example: |
|
In this position, the | Move the speaker |
speaker will likely | so that the screw is |
fall if moved to the | in this position. |
left or right. |
|
Reattaching the speaker cable to the stand
1 Remove the eight screws from the stand, and remove the speaker net.
Screw
2 Position the cable.
GETTING
1 Attach the cover plate to the front speaker
2 
Screw
Tighten securely.
1 Cover
plate
2 Drive a screw (not included) into the wall.
Ø4.0 mm 
Ø7.5 to 9.5 mm
Wall or pillar | 4.0 to 6.0 mm |
|
Approx. 15 cm
Press the speaker cable into the groove.
Cable
3 Attach the speaker net with the screws.
■Fitting speaker stands (not included)
(For center and surround speakers)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance between screws as shown in the diagram.
•The stands must be able to support over 10 kg.
•The stands must be stable even if the speakers are in a high position.
Example: Center speaker
Metal screw holes For attaching to speaker stands
5 mm, pitch 0.8 mm 
Plate thickness plus |
|
7 mm to 10 mm | 60 mm |
Speaker stand
(not included)
RQTX0055
9
RQT8043