Keys Fitness ET520D owner manual Step

Page 7
Put the Tension Controller cable end into the spring hook.
Pull the Tension Controller cable into the gap of the bracket.
Insert the Tension Knob (54) into the Upright Post
(38) and connect with the screw attached (55).

5.Connect the Monitor Cable (51) to the Computer (57) and secure the Computer with the Screws (56) already in the back

of the Computer. Pull the Tension Cable (53) out of the Handlebar Post (38) and connect to the Tension Knob (54) as in Steps 1 and 2:

Step 1:

Step 2:

5

6.Connect the Left Handlebar (64L) to the Left Handlebar Sleeve (67L) with Bolts (69), Washers (70) and Cap Nuts (71). Then slide the entire Left Handlebar Assembly onto the Handlebar Post (38) and secure with Washer (72) and Nut (6a). Once tightened, slide on the Plastic Cap (73) to cover the nut. Attach the Left Connect Tube (74L) to the bottom of the Left Handlebar Assembly using Screw (77), Washers (21) and Nut (39). Once tightened, slide on the Plastic Cap (78) to cover the nut.

Repeat step 6 on the right side of the unit.

64L

38

6

74L

These two parts are already connected

10

11

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Monday-Friday 830-530 Central Time ET520DKeys Elliptical Trainer Model ET520D Questions? Keys Fitness PRODUCTS, LP Limited WarrantySafety Precautions and Tips Important Safety InformationBefore You Start Assembly Parts Assembly Accessories Remove ALL Security Tape Wrapping Before Beginning Assembly of CardioMax Dual Action Elliptical TrainerPage Step NO. Part 520R Parts ListConsole Functions Old Batteries TroubleshootingMonitoring Your Heart Rate BatteriesMHR = Maximum Heart Rate Target Heart Rate Zone
Top Page Image Contents