Step 4: Attach Pedals |
|
| |||||
In order to mimic the fit and feel of your own bike, CycleOps IC do not |
|
| |||||
come with pedals. Attach your own pedals per the manufacturers’ specifications. |
|
| |||||
Note that pedals are designed to be installed specifically on the right or |
|
| |||||
side of the IC. Improper installation can result in damage to the crank. Damage |
|
| |||||
caused by improper crank installation is not covered under warranty. |
|
| |||||
Attach your pedals onto the bike with a pedal wrench. Typically, each |
|
| |||||
pedal is marked with an “R” or an “L” on the very end of the spindle past the threads. |
|
| |||||
This mark indicates which side of the bike the pedal is intended to mount on. |
| A | |||||
This is important since the thread directions are different for each pedal. |
| ||||||
|
| ||||||
A. Locate the pedal that has the “R” on the spindle. This pedal is for the right side crank |
| B | |||||
|
| ||||||
arm of the bike (chain guard side) and is right hand threaded |
|
| |||||
(turn clockwise to tighten). |
|
| |||||
B. Locate the pedal that has the “L” on the spindle. Turn the spindle left |
|
| |||||
wise) to tighten as the “L” spindle is reverse threaded. |
|
| |||||
Step 5: Attach Console Bracket and Console |
|
| |||||
|
| ||||||
Bracket |
| ||||||
When first setting up the CycleOps IC you must attach the console bracket to the bike. To |
| ||||||
do this, follow the instructions below: |
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Place bracket onto the handlebars as shown.
Insert screws through console bracket, handlebar bracket, and tighten together.
Slide the console down completely down onto the bracket. To ensure a solid con- nection between the console and the bracket make sure the contact points between the console and bracket remain clean and free from moisture or debris.
Batteries: The console ships with batteries. In the event the batteries need to be replaced over time, follow these simple steps:
Remove the back cover with a small
Remove batteries.
Replace with fresh AAA batteries, paying attention to properly line up the +/- poles.
Replace battery door and secure with small
3