CHAPTER 1:UNPACKING THE CYCLEOPS INDOOR CYCLE
Place the box upright and cut the plastic binding straps. Lift the top of the box to expose the Indoor Cycle (IC) and packaging. Remove all parts from the box and foam inserts and ensure all the following parts are included:
Part | Qty |
Indoor Cycle Frame | 1 |
Front V Foot | 1 |
Back V Foot with wheels | 1 |
Seat Post | 1 |
Handlebars | 1 |
Hardware | 1 |
Hardware |
|
Stabalizer bolts (8) | Tools Required |
Washers (8) | Vice Grips or small clamping tool |
Plastic cups(2) | 17mm Cone wrench |
15mm box wrench | |
5mm Allen wrench (1) | 10mm box wrench |
6mm Allen wrench (1) | Pliers |
15mm pedal wrench (1) | 3mm Allen wrench |
2.5mm Allen wrench |
CHAPTER 2: BIKE ASSEMBLY
Step 1: Attach Stabilizer Feet
1.Note the difference between the front and rear stabilizer feet. The larger foot with wheels goes in the rear of the IC.
2.Align the rear base of the frame with the rear stabilizer and secure it with four 6mm bolts with washers. NOTE: Tighten the inner bolts first, and then proceed to the outer bolts to ensure the foot is secured properly and evenly.
3.Repeat with the front stabilizer.
Rear Stabilizer Feet | Front Stabilizer Feet |
1