Cateye EC-35OO operating instructions Maintenance/Trouble Shooting/Specifications

MAINTENANCE/TROUBLE

SHOOTING/SPECIFICATIONS

1. Caution on Handling

For longer use, observe the following precautions.

•Don't disassemble the main unit or the control unit. Consult the dealer you purchased the unit from, in case of trouble.

•Avoid using this unit where it may be splashed with water or there is a high temperature or humidity.

•When the unit is not in use, be sure to turn the power off.

•Don't wipe the unit with organic solvents such as thinner, kerosene, gasoline or alcohol. Wipe it clean with a cloth with neutral cleanser, and wipe with a dry cloth.

•Wipe off the sweat drops on the main unit and control unit, after use.

•Don't leave the unit in the direct sun light.

2. Trouble Shooting

Trouble Check Item Suggested Remedy

ITEM	SPECIFICATIONS
Load	Eddy current system utilizing permanent magnet
Load Range	Manual Adjustment		1~8 level
	Cadence		50~120 rpm
	Load Range		25~680 watts
Acceleration	2-step chain drive incorporating timing belt
Control System	4-bit micro-computer
Display Function	Function	Range		Accuracy
	Pulse Rate	50 ~ 220 bpm		±	1 bpm (stable state)
	Cadence	20 ~ 240 rpm		±	1 rpm
	Exercise Time	00 min. 00 sec. ~ 99 min. 59 sec.		±	0.003 %
	Work Rate	0 ~ 999 watts		± 5 watts (at 50 watts)
	Speed	0 ~ 99 miles/h (km/h)		Simulated value
	Distance	0.00 ~ 99.99 miles (km)		Simulated value
	Calorie	0 ~ 999 kcal		Estimated value
Alarm Function	Target Pulse Rate Alarm

No display appears or a b n o r m a l d i s p l a y appears on the control panel.

Press the advance button and check if the display appears or not . Proceed "All - clear Process", and press the advance

button and check if the display appears or not. [Page 5-8 (Fig. 10)]

I f s t i l l n o d i s p l a y appears, the batteries are dead. Replace all four batteries. [Page 5- 8 ]

	Signals if the pulse rate deviates by ± 5 bpm from target pulse rate
	Upper-limit Pulse Rate Alarm
	Signals when pulse rate exceeds preset upper-limit pulse rate
	Exercise Time Alarm
	Signals when preset target exercise time is reached
Power Supply	AA (R6) x 4 (Battery life: Approx. 200 hours by alkaline battery)
User's Weight Limit	286 lbs (130 kg)

A b u z z e r b e e p s	Check if your upper-limit pulse	I n p u t y o u r		a g e
continuously.	rate (PLL) has been set correctly.	correctly. The upper-
	[Page 13-2]	limit pulse rate is set
		based on [200 - age].
"Distance Scale Unit"	Check if the distance scale unit	Follow instructions on
display is wrong.	was set correctly according to	page 5-7,8 to set the
	instructions. [Page 5-7]	desired distance unit.
The pulse rate reading	Check if the sensor plug is	Insert the sensor plug
is not displayed.	inserted properly. [Page 7-5]	properly, and attach the
		pulse sensor correctly.
	Check if the pulse sensor is
	correctly attached to your
	earlobe. [Page 11]
	Check if the plug or the cable of	In case of damage on
	the pulse sensor is damaged.	t h e p u l s e	s e n s o r ,
	[Page 11]	replace it with a new
		one.
The target pulse rate	Has your pulse rate once reached	The target pulse rate
alarm does not beep.	the target pulse rate? [Page 10]	alarm is activated only
		after your pulse rate
		reaches the target.
	Is the Target Pulse On/Off mark	Press the Target Pulse
	lit on the screen? [Page 10]	On/Off button		to
		turn on the	mark.

Measurement	Overall Length: 75-3/16 inches max. (1910 mm)
	Unit Hight: 14-31/32 inches max. (847 mm)
	Width: 22-1/16 inches (560 mm)
	Seat to Crank Axle Distance: 14-31/32 ~ 26-25/32 inches (380 mm ~ 680 mm)
	Seat Hight: 11-11/32 ~ 19-3/32 inches (288 mm ~ 485 mm)
	Crank Axle: 17-1/8 inches max. (435 mm) from floor
Weight	Net Weight: 73 lbs. approx. (33 kgs)

*Specifications and design are subject to change without notice. Pat. & Design Pat. Pending

Copyright© 1991

Cateye Co., Ltd.

Printed in Japan

ECME35-910925

18

19