Cateye EC-35OO Make each adjustment under the following process, Level Adjustment

ADJUSTMENT

Make each adjustment under the following process.

5

2

3

EC-35OO

cable holders

4

1

seat height lock knob

Ideal exercise posture

•Adjust the seat position as illustrated. Find the position where your knee is slightly bent when the pedal is at the farthest position.

• When moving the

EC-35OO	main unit, lift the rear
	frame holding by the
	seat height lock knob,
	and roll the casters.
	casters

1. Level Adjustment 2. Adjusting Seat Position

3. Adjusting Seat Height

5. Mounting Pulse Sensor

•Turn the level adjuster on the rear leg so that the unit is placed stably.

•When the indication line on the level adjuster is at the top, the rear leg is at the same level as the caster of the front leg.

7	8	indication line
5
	6
3	4
1	2
Fig. 1		level adjuster

The seat position can be adjusted while pulling up the seat lock pin. When desired seat position is obtained, release the lock pin free and move the seat slightly and the lock pin will click into the nearest hole by spring pressure. Holes are provided at an interval of 3 cm(1-3/16").

Note: When sliding the seat, take care not to break the pulse sensor cable.

PULL

lock pin

3 cm(1-3/16")

• The seat height can be adjusted at your choice.

• The higher the seat, the less intense the exercise or vice

versa.

• Loosen and remove the seat height lock knob, supporting

the seat pipe with the other hand.

• Move up or down the seat pipe to the desired height and

screw-in the seat height lock knob. While tightening the

knob lift the seat pipe slightly for easier screwing. Holes

are provided at an interval of 3 cm(1-3/16").

seat height

lock knob

• Insert the pulse sensor plug into the pulse sensor jack at

the side of the control panel.

• Attach the cable holders at the main frame and the seat

pipe. (Upper figure on page 6)

• Insert the sensor cable through the cable hooks and cable

holders. Hold the cable in position by attaching the sen-

sor clip at the bend of the handlebar. (Fig. 4)

• Allow enough slack in cable under the seat pipe for seat

adjustment.

• Attach the cable clip to your clothes during exercise to

avoid excessive swinging of the sensor cable.

• Attach the pulse sensor on the sensor clip when not in

use.

pulse sensor jack	Fig. 4
pulse sensor plug	pulse sensor

Fig. 2

6

Fig. 3

4. Adjusting Pedal Belts

It is possible to adjust the pedal belt length according to your shoes size.

	cable hooks
cable holders	sensor clip
	cable clip
7