Assembly

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included hex keys, assembly requires a Phillips screwdriver , an adjustable

wrench , and a rubber mallet .

See the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled.

If a part is not in the hardware kit, check to see if it has been preassembled.

M8 Split	M10 Split	Wave Washer	M8 Washer	M8 Nylon	M10 Nylon
Washer (83)–2	Washer (94)–2	(91)–2	(53)–6	Locknut (46)–6	Locknut (29)–4

M4 x 16mm	M4 x 22mm	M8 x 16mm Button	M8 x 25mm Patch	M8 x 45mm Button
Screw (66)–8	Screw (76)–2	Screw (84)–4	Screw (22)–2	Bolt (50)–4

M8 x 70mm Button Bolt (67)–2		M10 x 59mm Bolt Set (27)–2

M10 x 75mm Carriage Bolt (34)–2

M10 x 83mm Button Screw (63)–2

M10 x 45mm Button Bolt (33)–2