4.The Console (87) requires two ÒAAÓ batteries (not included). Alkaline batteries are recommended. To install batteries, turn the console over and insert two batteries into the battery clip as shown in the inset drawing. Make sure that the negative ends of the batteries (marked ÒÑÓ) are touching the springs in the battery clip.
Attach a Plastic Tie (90) to the battery clip as shown.
Attach the Console (87) to the Console Base (49) with the four gold #8 x 1/2Ó Screws (88), making sure that the indicated wires are extending from the Console Base (49). Be careful not to pinch the wires.
5.Connect the Reed Switch Wire (50) to the correspond- ing wire on the Console (87).
Next, connect the two Pulse Wires (86) to the two remaining wires on the Console (87). Note: Either Pulse Wire can be attached to either wire on the Console.
Next, connect the ground wire to the indicated hole in the Upright (2) with the #8 x 3/4Ó Screw (93) and the #8 Star Washer (53).
Carefully feed the wires down into the Upright (2). Attach the Console Base (49) to the Upright with four #8 x 3/4Ó Screws (35). Be careful to avoid pinching the wires.
6.Refer to the inset drawing. Apply a small amount of the included lubricant to a paper towel; rub a thin film of lubricant onto the Chrome Extension Tube (21) on the Right Pedal Arm (4). Slide the Chrome Extension Tube into one of the Upper Body Arms (7).
Slide the other Chrome Extension Tube (21) into the other Upper Body Arm (7) in the same way.
Tap a 5/8Ó Axle Cap (85) onto one end of the Axle (19). Insert the Axle through one of the Upper Body Arms
(7) and then through the Upright (2). Slide the other Upper Body Arm (7) onto the Axle. Make sure that the Upper Body Arms are turned as shown. Tap another 5/8Ó Axle Cap (85) onto the Axle.
4 |
|
| Batteries |
|
| 87 |
|
|
|
| 90 |
|
|
| Battery |
|
|
| Clip |
49 |
|
|
|
| Wires |
| |
|
| 88 |
|
5 |
|
|
|
|
|
| 87 |
| Console |
| |
|
| Wires | 49 |
|
|
| |
|
| 86 | 93 |
|
|
| |
|
| 50 | Ground Wire |
|
|
| |
|
| 53 | |
|
| 73 |
|
| 35 | 2 |
|
|
|
| |
6 |
|
|
|
|
|
| 7 |
|
| 85 | 21 |
|
|
| Lube |
|
| 19 | 4 |
85 |
| 7 |
|
| 7 | 2 |
|
|
|
| |
7.Make sure that all parts of the elliptical crosstrainer are properly tightened. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer.
6