Assembly

Before beginning assembly, carefully read the following information and instructions:

•Assembly requires two persons.

•Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.

•Read each assembly step before you begin.

•To identify the small parts used in assembly, use the part identification chart below. The num- ber in parenthesis below each part refers to the key number of the part. The second number refers to the quantity needed for assembly. Note:

Some parts may have been pre-attached for shipping purposes. If a part is not in the parts bag, check to see if it has been pre-attached.

•Tighten all parts as you assemble them, unless instructed to do otherwise.

•During assembly, make sure that all parts are ori- ented as shown in the drawings.

THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:

•Two adjustable wrenches

•Lubricant, such as petroleum jelly or grease, is also required.

Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches, and a rubber mallet.

Plastic Washer (49)–2	M6 Flat Washer (55)–4	Rubber Washer (51)–4
M6 Hex Nut (54)–4	Axle Fastener (56)–4	M8 Nylon Jam Nut (7)–2
	(either Bolts or Acorn Nuts)
M6 x 60mm Bolt (53)–4		M8 x 1.375” Bolt (17)–1
Frame Axle (13)–2 (Internal Thread)
	OR
Frame Axle (13)–2 (External Thread)
	M8 x 120mm Bolt (57)–1
	4