Using the CD Player
❑You can insert a CD while listening to the other source.
•However, while the CD door is operating (opening or closing), the other source will be muted.
CAUTION:
•DO NOT try to open or close the CD door by hands as it will be damaged.
To Unload a CD
Take out the CD as shown below.
Basics of Using the CD Player
– Normal Play
To Play a CD
1 Select the source “CD”.
2 Insert a CD.
3 Press the 6button on the Unit or the CD 6button on the Remote Control.
The first track of the CD begins playing.
Track number | Playback time |
•The CD Player automatically stops when the last track of the CD has finished playing.
To stop playing the CD, press the 7 button. The following information for the CD is displayed.
Total track number | Total playback time |
To stop playing and remove the CD, press the 0CD button on the Unit or the CD DOOR 0 button on the Re- mote Control to open the CD door.
To pause, press the 6button on the Unit or the CD 6 button on the Remote Control. The playback time blinks on the display.
To cancel pause, press the same button again. Play con- tinues from the point where it was paused.
To Select a Track or Passage within a Track
During playback
Press the ¢ or 4 button on the Unit or the 3 or 2 but- ton on the Remote Control to select the track you want.
•The selected track starts playing.
•Press the ¢ (or 3) button once to skip to the beginning of the next track.
•Press the 4 (or 2) button to skip to the beginning of the track being played. Press twice quickly to skip to the beginning of the previous track.
•When the 3 or 2 button on the Remote Control is kept pressing, the track continuously skips.
•Press the Numeric Keys to select truck number (See page 11).
In Stop mode
•Press the ¢ or 4 (or 3 or 2) button to skip the track.
•Hold down the ¢ or 4 (or 3 or 2 ) button to continuously skip the tracks.
Search Play
Holding down the ¢ or 4 button on the Unit or the 5 or ∞ button on the Remote Control, during playback, will fast forward/backwards the CD so you can quickly find a particular passage in the track you are listening to.
Programming the Playing Order of the Tracks – Program Play
You can program up to 32 tracks in any desired order in- cluding the same tracks.
❑You can only make a program when the CD Player is stopped.
On the Remote Control
1 Insert a CD.
2 Press the CD 6button.
3 Press the 7 button to stop the CD.
4 Press the FM/PLAY MODE button until “CD PROGRAM” appears.
The System enters the Program Play mode and the “PRGM” indicator lights up.
Each time you press the button, the play mode changes as follows.
CD PROGRAM=CD RANDOM=CD NORMAL= (back to the beginning)
(After a few seconds)
•If already programmed, the track number and preset number of the last programmed track will appear.
18