Fostex VF-16 owner manual Saving data using a CD-RW drive

Saving data using a CD-RW drive

In the following procedure, we assume that a CD- RW drive is connected to the VF-16 SCSI port and a non-recorded CD-RW disc is used.

<Note>

Do not carry out any VF-16 key operation until the ac- cess process to the CD-RW disk is completed.

1.After turning on both the VF-16 and the CD-RW drive connected, insert a disc to the CD-RW drive.

2.Press the [SETUP] key of the VF-16 to enter the setup mode.

The display shows the screen for selecting the setup menu.

5.After selecting a program, press the [ENTER/YES] key.

The display shows a screen as below.

Flashing

3.Use the [JOG] dial to select (highlight) "Save PGM" and press the [ENTER/YES] key.

The display shows the screen for selecting a save device, where "SCSI" is flashing.

In the example above, the selected program data will be saved to a CD-RW disc with the backup number "B01". The program title is copied to the backup title (you can not edit it).

By rotating the [JOG] dial when the above screen is shown, you can also select "Eject", besides "B01."

If you select "Eject" and then press the [ENTER/YES] key, the disc will be ejected.

6.While "B01" is shown, press the [ENTER/YES] key.

The VF-16 starts the save operation. The recorded space shown on the display is counted down while the save operation progresses. It will take some time for saving all data. The following display example shows that the data of the selected program number is being saved to the backup number "B01."

Flashing

4.While "SCSI" is flashing, press the [ENTER/YES] key.

After showing the model name of the CD-RW drive, the display shows the screen for selecting a program to be saved (the program number of the selected program flashes).

When completing the save operation, "Save Completed!" appears on the display (as shown below) and the VF-16 stops access to the drive, while the disc in the CD-RW drive is automatically ejected.

Flashing

R e c o r d e d	When saving data to more than one disc, the first disc
space
	will be ejected when it is full (i.e. there is no more
	recording space on the disc), while "Insert Disk!" appears
	on the screen. After inserting the second disc, the VF-16
By rotating the [JOG] dial, you can select a desired	automatically resumes the save operation.
	After completing the save operation, the final disc is
program number/title from among available programs
	ejected and the above screen appears. (See <Note> on the
in the VF-16 current drive. The recorded space of the
	next page.)
selected program is also shown.
If you select a program which requires more than one	7. Press the [EXIT/NO] key (or the [STOP] key) to exit the
disc for saving, the display shows the required number
of discs (see the screen example below).	setup mode.

4