Fostex VF-16 owner manual About load error, While New PGM is shown, press the ENTER/YES key

When you load song data which is saved to	<Note>
more than one disc, the display also shows the	If there is not enough available space for loading on
disc number currently set. The example below	the current drive, the display shows "Disk Full!" and
	the display returns to the previous screen.
shows DISC-1 is set.

	When completing the load operation, "Load Completed!"
	appears on the display (as shown below) and the VF-16
	stops access to the drive, while the disc in the CD-RW
Flashing	drive is automatically ejected.

Lighting

5.While the desired backup number/title is shown on the display, press the [ENTER/YES] key.

The display shows the screen for creating a new program on the current drive, to which data will be loaded ("New PGM" lights).

Flashing Lighting

As described earlier, when loading data from a CD-RW drive, the VF-16 creates a new program on the current drive, which is the load destination.

Therefore, "New PGM" is shown on the right of the flashing program number.

The program number for the newly created destination program is the next number to the highest existing program number.

For example, if there are 8 existing programs (P01 through P08) on the current drive, the newly created program is numbered "P09."

<Note>

If you rotate the [JOG] dial while the above screen ("Destn PGM Select") is shown, you can select an exist- ing program on the current drive as the destination. However, as mentioned earlier, when loading data using CD-RW you cannot actually load data to the ex- isting program by overwriting the program data.

If you press the [ENTER/YES] key (see the next step) while selecting an existing program as the destina- tion, the display shows "Void!" and the VF-16 ignores the operation.

6.While "New PGM" is shown, press the [ENTER/YES] key.

The VF-16 starts the load operation. The recorded space shown on the display is counted down while the load operation progresses. It will take some time for loading all data. The following display example shows that the data of the backup number "B01" is being loaded to "P08" which is newly created on the current drive.

When loading data from more than one disc, the first disc will be ejected immediately after all disk data has been loaded, while "Insert Disk!" appears on the screen. After inserting the second disc, the VF-16 automatically resumes the load operation. After completing loading all the discs, the above screen appears.

<Note>

You cannot abort the load operation before completed.

7.Press the [EXIT/NO] key (or the [STOP] key) to exit the setup mode.

<About load error>

If an error occurs for some reason during the load operation, the error message as below appears.

If it appears, press the [EXIT/NO] key.

The display returns to the previous screen before performing the load operation.

Note that loaded data before the error message appears is all invalid.

<Display example for loading>

7