coin. (See Figure 3A) If, after battery replacement, the LCD display is blank or shows incomplete digits, turn the computer over and press the "AC" button on the bottom of the case with the tip of a pen or a paper clip. This will clear all the data and
replace the battery, make a note of your odometer reading and
wheel circumference set- tings before removing it. You can then
data when you restart the computer.
FIGURE 3A.
4
Replacing the
Transmitter Battery
The Wireless Transmitter comes with the battery installed at the factory. When the battery in the transmitter needs replacing, it will transmit a sig- nal to your SpeedZone® Pro and the
Dot Matrix Display Area will show "LOBAT". If you
need to replace this bat- tery, use a coin to
unthread the battery cap from the transmitter hous- ing. Install the battery (model CR2032, Specialized P/N 481- 3004) with the positive pole
(+)facing upward. (See
Figure 3B) Carefully thread the battery cap back onto the case with a coin.
MOUNTING
THE
SPEEDZONE®
PRO:
There are two
transmitters includ-
ed with your SpeedZone® Pro. One transmitter is
for speed and the other is for cadence. Please
note that that they are marked with a WHEEL (speed transmitter) icon or a CRANK (cadence transmitter) icon. It is very important that you mount them in the correct locations on your bicy- cle. The wireless speed transmitter can mount on the right or the left side of the fork blade. The right side should
be used on large frames or when a suspension fork is installed. The opti- mal distance between the computer and the transmitter is 24 inches (610mm). To reduce signal loss in colder temperatures, the transmitter should be mounted as close to the
computer as possible. (Maximum mounting
distance is 47 inch-
es/1200mm).
Assemble the trans- mitter to the mount with the provided
screw. Use the tie-
wraps provided to position the transmit- ter on the fork leg. Do not tighten the tie- wraps until final
5