Huffy 89025 manual Model

Page 1

A Huffy Company

Customer Service

N53 W24700 South Corporate Circle

Sussex, WI 53089

U.S.A.

Model 89025

Please refer to modular category #350 when arranging product for modular display.

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY

RESULT IN SERIOUS INJURY,

PROPERTY DAMAGE AND WILL VOID WARRANTY.

This unit is intended for display purposes only and

should not be used for play.

To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check entire box and inside all packing material for parts. Before beginning assembly, read the instructions and identify parts in this document. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly.

During assembly, if using a ladder use extreme caution. Two people are recommended for this operation.

If technical assistance is required, contact Huffy Sports’ Sample and Display Technician.

Serious injury could occur if teeth/face come in contact with backboard, net or rim.

Display recommended for 3” (7.6 cm) or 3-1/2” (9 cm) Round or 4” (10 cm) Square poles only.

All instructions and warnings MUST accompany any display item that is sold.

Most injuries are caused by misuse and/or not following

instructions.

Use caution when installing this unit.

REQUIRED TOOLS AND

MATERIALS:

2 People

Wrenches: (Two each) 7/16”, 1/2”, 9/16”, and 3/4” or Pliers

Phillips Screwdriver

2 Step Ladders, 8 ft. (2.4 m)

IMPORTANT!

We appreciate your purchasing one of our many fine products. We are sure that you will be very satisfied with your selection. Although great care and effort have been taken, problems may occur. To ensure prompt and correct handling of any problems, or to answer any questions, please contact the Sample and Display Technician at 414-820-3440.

Internet Address: http://www.huffysports.com

1

06/03 P/N 211543B

Image 1
Contents Model Display Stand Top View Assemble rims as shown below RIM Assembly Corner Locations 1Clip ARM Clip Body NET Installation Page Elevator Assembly Corner Locations 1 Steel Frame Acrylic Backboard Assembly Corner Location 06/03 P/N 211543B FAN Molded Plastic Board Assembly Corner Location 06/03 P/N 211543B As shown Height Adjustment FAN Molded Plastic Board Elevator Assembly Corner Location Shown As shown Fig. B Fig. C 06/03 P/N 211543B FAN Backboard Assembly Corner Location Parts List See Hardware Identifier Hardware Identifier Bolts & Screws