Initial Tool SET UP Assembly, Unpacking | Harbor Freight Tools 1102

Specifications

	Max. Air Pressure	90 PSI
	Air Inlet	Schrader (Bicycle) Valve
	Capacity	16 fluid ounces
		Coarse Spray (Green)
		Medium Spray (Black)
	Spray Buttons (4)	Fine Spray (Blue)
	Spray Buttons (4)	Jet (No color; equipped
		Jet (No color; equipped
		with opening for jet spray
		extension)

Air Supply

TO PREVENT

EXPLOSION:

Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool.

INITIAL TOOL SET UP/

ASSEMBLY

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.

Unpacking

When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown throughout the manual as soon as pos- sible.

•This air tool may be shipped with a protective plug covering the air inlet. Remove this plug before set up.

1.Incorporate an in-line shut-off valve, regulator with pressure gauge, and filter for best service, as shown in the diagram above. An in-line shutoff valve is an important safety device because it controls the air supply in the event of an air hose rupture or other emergencies.

2.Attach a tire chuck to one end of the air supply hose and the other end of the hose to the air supply (neither one is supplied.)

Note: Air flow, and therefore tool perfor- mance, can be hindered by under- sized air supply components.

SKU 1102

For technical questions, please call 1-800-444-3353.

Page 5