Troubleshooting
Problem |
| Possible Causes |
| Likely Solutions |
Spray only “jets”. | 1. | Can is overfilled. | 1. | Make sure can is not filled over 50 percent |
|
|
|
| with liquid. |
| 2. | Product is too thin. | 2. | Add product with correct thickness. |
| 3. | Incorrect air pressure. | 3. | Make sure air pressure is between 50 and 90 |
|
|
|
| PSI. |
| 4. | Button has been blocked. | 4. | Clean or replace clogged button. |
| 5. | Broken Spray Button. | 5. | Pry out Spray Button and replace with new |
|
|
|
| one. Do not insert anything through supply |
|
|
|
| tube attached to the valve body. |
Air bubbles | 1. Incorrect air pressure. | 1. | Make sure air pressure is between 50 and 90 | |
appear in sprayed |
|
|
| PSI. |
material. |
|
|
|
|
2.Using incorrect Spray Button. 2. Switch Spray Buttons and apply finer coating before coating dries.
Severe air | 1. | 1. | Back off and reattach. | |
leakage. |
|
|
|
|
| 2. | Damaged valve or housing. | 2. | Replace damaged components. |
| 3. | Dirty, worn or damaged | 3. | Replace Sealing Gasket. |
|
| Sealing Gasket. |
|
|
| 4. | Loose or bad valve core. | 4. | Tighten/replace valve core. |
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect air supply before service.
SKU 1102 | For technical questions, please call | Page 8 |