Jenn-Air JDRP430 Troubleshooting, Nothing will operate, Cooktop cooking results not what expected

Models: JDRP430

1 72
Download 72 pages 6.5 Kb
Page 31
Image 31
TROUBLESHOOTING

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

Nothing will operate

 

Cooktop cooking results not what expected

Has a household fuse blown, or has a circuit breaker tripped?

Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.

Surface burners will not operate

Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines.

Is the control knob set correctly? Push in knob before turning to a setting.

Are the burner ports clogged?

On sealed burner models, see “Sealed Surface Burners” section.

Surface burner flames are uneven, yellow and/or noisy

Are the burner ports clogged?

On sealed burner models, see “Sealed Surface Burners” section.

On models with caps, are the burner caps positioned properly?

See “Sealed Surface Burners” section.

Is propane gas being used?

The range may have been converted improperly. Contact a trained repair specialist.

Surface burner makes popping noises

Is the burner wet? Let it dry.

Burner sparks but does not light

Is there continuous sparking, but the burner does not light?

Discontinue use of the surface burner and contact a service technician.

Excessive heat around cookware on cooktop

Is the cookware the proper size?

Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ¹⁄₂" (1.3 cm) outside the cooking area.

Is the proper cookware being used? See “Cookware” section.

Is the control knob set to the proper heat level? See “Cooktop Controls” section.

Is the range level?

The range must be level for the griddle to operate properly. See the Installation Instructions for leveling instructions.

Oven will not operate

Is the electronic oven control set correctly? See “Electronic Oven Control” section.

Has a delay start been set?

See “Timed/Delay Cooking” section.

Is the Control Lock set? See “Control Lock” section.

Is the Sabbath Mode set? See “Sabbath Mode” section.

Oven temperature too high or too low

Does the oven temperature calibration need adjustment? See “Temperature Calibration” in the “Setup Menu” section.

Display shows messages

Is the display showing a letter followed by a number? Clear the display. See “Display(s)” section. If a letter followed by a number reappears, call for service. See “Assistance or Service” section.

Self-Cleaning cycle will not operate

Is the oven door open?

Close the oven door all the way.

Has the function been entered? See “Self-Cleaning Cycle” section.

On some models, has a delay start Self-Clean cycle been set?

See “Self-Cleaning Cycle” section.

Has a delay start been set?

See “Timed/Delay Cooking” section.

On 48" (121.9 cm) ranges, is one oven self-cleaning? When one oven is self-cleaning, the other oven cannot be set to self-clean.

31

Page 31
Image 31
Jenn-Air JDRP430 Troubleshooting, Nothing will operate, Cooktop cooking results not what expected, Oven will not operate