Jenn-Air JDRP430 manual Oven Lights, Oven Door, Griddle Module, To Replace, To Remove

Models: JDRP430

1 72
Download 72 pages 6.5 Kb
Page 30
Image 30
GRIDDLE MODULE

GRIDDLE MODULE

Clean the griddle shortly after removing food and the griddle has cooled down.

Cleaning Method:

Hot, soapy water and/or nylon scrub pad

After cleaning dry surface with a paper towel

Drip Tray and Area Under Tray

Allow cooktop to cool completely before cleaning.

Cleaning Method:

Warm, soapy water or nonabrasive cleanser.

Damp cloth or nonabrasive pad.

Dry completely before placing drip tray in position.

Oven Lights

The oven lights are 120-volt, 25-watt maximum halogen bulbs. They will come on when the oven door is opened.

On 48" (121.9 cm) ranges, both the left and right oven lights turn on or off when OVEN LIGHT is pressed. The oven lights will not work during the Self-Cleaning cycle. When the oven door is closed, touch OVEN LIGHT to turn light on or off.

To Replace:

Before replacing the bulb, make sure the oven is off and cool.

1.Disconnect power.

2.Remove glass light cover by grasping the front edge and pulling away from oven.

3.Remove bulb from socket.

4.Replace bulb, using tissue or wearing cotton gloves to handle bulb. To avoid damage or decreasing the life of the new bulb, do not touch bulb with bare fingers.

5.Replace bulb cover by snapping back into wall.

6.Reconnect power.

Oven Door

Oven LightsWARNING

Excessive Weight Hazard

Use two or more people to move and install oven doors.

Failure to do so can result in back or other injury.

For normal range use, it is not suggested to remove the oven door. However, if removal is necessary, make sure the oven is off and cool. Then, follow these instructions. The oven door is heavy.

To Remove:

1.Open oven door all the way.

2.Flip up the hinge latch on each side.

3.Close the oven door as far as it will shut.

4.Using 2 or more people, lift the oven door while holding both sides.

Continue to push the oven door closed and pull it away from the oven door frame.

To Replace:

1.Using 2 or more people, lift the oven door and insert both hanger arms into the door.

2.Open the oven door.

You should hear a “click” as the door is set into place.

3.Move the hinge levers back to the locked position. Check that the door is free to open and close. If it is not, repeat the removal and installation procedures.

30

Page 30
Image 30
Jenn-Air JDRP430 manual Oven Lights, Oven Door, Griddle Module, To Replace, To Remove, Excessive Weight Hazard