1. Before proceeding, familiarize yourself with the parts of the Stairclimber and make sure that you have received all the items described in the Parts List.
2. Locate the MONOCOLUMN (#10). Position the MONOCOLUMN SHROUD (#16) onto the MONOCOLUMN as shown. Position the MONOCOLUMN near the MONOCOLUMN MOUNTING BRACKET
(A) as shown. Detach and feed the CONSOLE WIRE HARNESS (B) and COAXIAL CABLE (CX) through the MONOCOLUMN and out through the DISPLAY CONSOLE MOUNTING BRACKET (C) ACCESS HOLE. Pivot the MONOCOLUMN upright and position the locating slot at the bottom of the MONOCOLUMN onto the pre- installed LOCATING BOLT (D) on the MONOCOLUMN MOUNTING BRACKET. Align the mounting holes of the MONOCOLUMN and MONOCOLUMN MOUNTING BRACKET and secure them together using two MOUNTING BOLTS (#1) and LOCKNUTS (#2). Leave the BOLTS and NUTS loose at this time. Lower the MONOCOLUMN SHROUD until it rests on the MAIN SHROUDS.
CAUTION: Be careful not to pinch the COAXIAL CABLE or WIRE
HARNESS (C).
MISE EN GARDE : veillez à ne pas pincer le CÂBLE COAXIAL ou
CÂBLE PRINCIPAL (C).
3. Align and insert the HANDLEBAR ASSEMBLY (#15) into the HANDLEBAR BRACKET TUBE (E) as shown until the mounting holes in the HANDLEBAR ASSEMBLY align with those of the
HANDLEBAR BRACKET TUBE.
4. Locate the HEART RATE CABLE (#18). Feed the | 1 | ||
end of the cable through the front of the HANDLEBAR ASSEMBLY (#15). | |||
The cable must be routed down the HANDLEBAR BRACKET TUBE (E) and |
| ||
back up the top of the MONOCOLUMN (#10). Feed the | D | ||
through the DISPLAY CONSOLE MOUNTING BRACKET (C) ACCESS | A | ||
HOLE. Pull the LEFT HEART RATE SENSOR CABLE (2PL) (Labeled LEFT) | |||
| |||
through the LEFT LARGE HOLE (F) of the HANDLEBAR BRACKET TUBE. |
| ||
Pull the RIGHT HEART RATE SENSOR CABLE (2PR) (Labeled RIGHT) |
| ||
through the RIGHT LARGE HOLE of THE HANDLEBAR BRACKET TUBE. |
| ||
C | C | 15 | |
4P |
| ||
A
CX
B
16
10
C
10
16
2
15F
10
10
E 2P
E