Life Fitness 95Se manual 14 2P 2PR 2PL 2P

5.Locate the USER LEFT BULLHORN (#13) with a Lifepulse sensor. Connect the 2-PIN CONNECTOR (2P) leading from the USER LEFT BULLHORN to the 2-PIN CONNECTOR (2PL) now leading from the HANDLEBAR BRACKET TUBE (E). Carefully feed any excess HEART RATE CABLE (2PL) into the HANDLEBAR BRACKET TUBE and secure the USER LEFT BULLHORN to the HANDLEBAR BRACKET TUBE using three MOUNTING SCREWS (#6). Tighten the SCREWS securely. Repeat the procedure for the USER RIGHT BULLHORN (#14) with a Lifepulse sensor.

6.Position the COVER (#19) over the center of the HANDLEBAR ASSEMBLY (#15) at the HANDLEBAR BRACKET TUBE. Making sure the COVER is oriented properly, slide the COVER over the HANDLEBAR covering the end of the HANDLEBAR BRACKET TUBE. The COVER should fully nest over the HANDLEBAR ASSEMBLY. Secure the COVER using two MOUNTING SCREWS (#8).

CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS CAP HEAD SCREWS (#8).

MISE EN GARDE : NE SERREZ PAS EXCESSIVEMENT LES VIS CRUCIFORMES À TÊTE CYLINDRIQUE (Nº 8).

7.Locate one of the VERTICAL HANDRAILS (#12). Carefully insert the top of the VERTICAL HANDRAIL into the user right end of the HANDLEBAR ASSEMBLY (#15). Align the mounting holes. Secure the VERTICAL HANDRAIL to the HANDLEBAR ASSEMBLY using two MOUNTING SCREWS (#4). Position the bottom of the VERTICAL HANDRAIL over the mounting hole in the top of the right FRAME LEG (G). Using one HEX HEAD BOLT (#3), mount the VERTICAL HANDRAIL to the right FRAME LEG as shown. Tighten the BOLT securely. Repeat the procedure for the remaining VERTICAL HANDRAIL (#12) on the left side of the HANDLEBAR ASSEMBLY and FRAME.

Lift the MONOCOLUMN SHROUD (#16) and tighten the MONOCOLUMN BOLTS (#1) securely.

CAUTION: DO NOT OVER-TIGHTEN THE BOLTS (#1).

MISE EN GARDE : NE SERREZ PAS TROP LES BOULONS (Nº 1.)

14 2P

2PR 15

2PL 2P

E 6

10 13

19

8

15

E 8

15

4

12

G

3