Spalding M316001 manual Before YOU Start

Page 6

BEFORE YOU START!

To ensure optimal playability of backboard system, a close tolerance fit between the elevator components and hardware is required. Test-fit large bolts into large holes of elevator tubes, backboard brackets, and triangle plates. Carefully rock them in a circular motion to ream out any excess paint from holes if necessary. Not all parts shown are included with every system.

SECTION A: ASSEMBLE THE ELEVATOR MOUNT TO

DIFFERENT MOUNT SURFACES (POLE, WALL & ROOF)

Identify elevator tubes (30).

Toward

Mount

30

Elevator Tubes

Toward

 

Board

 

 

 

ID# M316001

01/07

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Universal Elevator Mount Safety Instructions Remove all contents from box Hardware Identifier Actual Size Bolts and Screws #12 Before YOU Start Assemble the Elevator Mount to a Square Pole Assemble the Elevator Mount to a Round Pole Assemble the Elevator Mount to a Wall or Flat Surface Assemble the Elevator Mount to a Flat or Angled Roof Flat or Angled Roof Section B Completed Assembly Attach a Composite Style Backboard Style will VaryHeight Adjustment and Warning Label Placement Backboard Mounting
Top Page Image Contents