Spalding M88724C manual End of the rod 14 as shown Figure a

Page 14

	13.	Before starting rim assembly, tighten nut (26) until it is positioned 6-3/4” from
	13.	the end of the rod (14) as shown (Figure A).
		the end of the rod (14) as shown (Figure A).

Remove rim cover (16), attach rim assembly (3) to backboard (10) and reattach rim cover (16).

** For rim assembly, see instructions included with rim.

14 26

FIGURE

A.

5

6

6

10

IMPORTANT!

Carefully cut and peel protective film away from board prior to attaching rim.

Rim Assembly

3

15

15

8 7

16

Refer To Instructions

Included With Rim

Hardware For Rim

Assembly.

ID# M88724C

10/05

14

Image 14

Contents High End Residential In-Ground Basketball System Safety Instructions Parts List Hardware Identifier Bolts & Screws Make sure nuts 25 are 2.75 7 cm from top of J-bolts Side V IEW Build drainage hillTypes are Identified With a letter Playing Surface Mounting plate 2 as shownCompleted Assembly ID# M88724C 10/05 Attach elevator adjustment 12 to Lower yokeAttach elevator adjustment 12 to pole bracket Yokes 18 Using TWO people to hold the boardAttach backboard 10 to upper and lower First attach board 10 to upper yokeEnd of the rod 14 as shown Figure a Install net 4 to rim as shown Apply height indicator labels 32 & 31 to height indicatorsAttach height indicators To lower yoke in areaNing 10/05 ID# M88724C Check system leveling. Pole Should be level in all directionsLimited Lifetime Warranty