Wenger 70832 instruction manual Setting the Moon Phase, Setting the Primary Tide

Setting the Moon Phase

Important Note: It is recommended that you set the Moon Phase during a Full Moon in your local area. Setting the Moon Phase Indicator by estimating may cause inaccuracies. For practical purposes you may approximate the phase of the moon and set the watch accordingly but always recalibrate at a full moon.

Setting the Primary Tide

Important Note: It is recommended that you set the Tide Indicator Hand at exactly High Tide or exactly Low Tide in your local area.

Read the “Your Tide Watch” section on pages 5 and 6, and refer to the General Features and Components illustration on page 3 for more information on the Primary Tide indicators.

Full moon

First quarter

New

moon

1.Refer to a Moon Phase chart from newspapers, the internet or marine sources. Note the current phase of

the moon at your location.

2.Press the Top Pusher for approximately 2 seconds until you hear a beep (see #4 below). Release it.

Last

quarter 3. Press the Top Pusher again to advance the small red Moon Phase Indicator to the appropriate phase.

Hold the Top Pusher down to advance more quickly.

1.	Refer to a Tide Chart for your local area and determine the time of High or
	Low Tide for today.
2.	At exactly High Tide or exactly Low Tide depress the Bottom Pusher for
	approximately 2 seconds until you hear a beep (see #4 below). Release it.
3.	Press the Bottom Pusher to advance the Tide Indicator Hand to either the
	“High Tide” (12:00 position) or “Low Tide” Indicator (6:00 position) depend-
	ing on the present tide. Hold the Top Pusher down to advance more quickly.

4.If left idle for 3 seconds, watch will beep again and auto- matically exit the setting mode.

5. The small red Moon Phase Indicator will make one revolution every 29 days.

4. If left idle for 3 seconds, watch will beep again and exit the setting mode.

8 9