Coleman 9234-121 manual Attach Rainfly, Attach Tent to Frame Using Frame Clips, Illus

Page 2
Rainfly pole in grommet
illus. 7 Insert rainfly poles through the
4 pole sleeves on underside of rainfly

3 Attach Tent to Frame Using Frame Clips

–Attach frame clips along

the edges of tent to frame poles. (illus. 5), (illus. 6)

–Make any adjustments to the tent corner stakes that are needed.

NOTE:

Grommets for rainfly pole are on frame clip webbing

illus. 6

Assembled tent without rainfly.

illus. 5

Frame clips

4 Attach Rainfly

–Assemble rainfly poles by interlocking shock-corded poles.

–Insert rainfly poles through pole sleeves located at the center of the curved edges of the underside of rainfly. (illus. 7), (illus. 9)

–Drape rainfly over tent frame, pole side down. Rainfly poles should be over door, rear and sides of tent.

–Connect the eight elastic loops with hooks, (found at the rainfly corners) to the eight fabric loops on

the bottom row of frame clips. (illus. 8), (illus. 9) –Insert the tips of the rainfly poles into the grommets on the frame clip webbing. (See above illus. 6) –Secure rainfly with attachments

located on underside of fly. (illus. 8)

illus. 9 Completed tent with rainfly.

Rainfly pole

through

pole sleeves

Underside of rainfly attaches to frame poles

Hooks attaches

to fabric loop

illus. 8

Rainfly hooks attach to fabric loops on the corner frame clips (illus. 8)

Things You Should Know

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

Seam sealer has not been provided with your tent. For additional protection we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

PRINTED IN SRI LANKA Rev. 9/04

Do not leave your tent set-up for weeks at a time, be aware that expo- sure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous con- tact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN SRI LANKA

Image 2
Contents Crescent RIM XL 12’x12’ Layout & Positioning of Tent, Pole AssemblyWhen You Are Ready To Set Up Your Tent Connect Frame to TentLocated on underside of fly. illus Attach Tent to Frame Using Frame ClipsAttach Rainfly Illus