Coleman 2000002596 To Attach Rainfly, Self-rolling Windows, Cooler Access, Electrical Cord Access

Sleeve

Fig. 18

Color “Flag”

Color

Dot

Fig. 19

Push in at top to

engage “spring(s)”

To Attach Rainfly

1.Drape Rainfly over tent. Make sure seams on Rainfly are facing down and centered over curved Ridge Poles at sides of the tent as shown. (Fig. 17)

NOTE: Large hook and loop fasteners, located at the ends underside of Rainfly, should be centered over ends of tent.

2.Press hook fastener flaps on underside of Rainfly onto loop pads on ends of tent to secure. (Fig. 17A)

3.Wrap hook & loop fastener on underside of Rainfly around center Leg Poles at front and back of tent. (Fig 17B)

4.Insert metal hook on elastic straps on Rainfly into the hole on each Leg Pole. (Fig. 17 & 17C)

17A

17B

17C

Rainfly

Door

Side of Tent

Front of Tent

Fig. 17

5. Stretch guylines until taut, then secure with stakes. (Fig. 17D)

17D

Self-rolling Windows

CAUTION: “Springs” may have sharp edges. Handle with care to avoid injury.

Keep out of reach of children.

NOTE: Carefully unroll metal “springs” stored in bag with stakes. The color

marking on each “spring” should match the color of the fabric “flag” sewn to
the window or door sleeve opening. (Fig. 18)
	Color “Flag”
1. Locate sleeve(s) in window panel, open hook &
loop fastener; then insert “spring(s)” with match-

ing color marking. (Fig.18 & 19)

NOTE: When inserting into the sleeve(s), the color marking on the “spring(s)” should always face the operator.

2.Close hook & loop fastener to secure.

3. Before unzipping and opening the window, push in at top to engage “spring(s)” to activate the self-rolling feature. (Fig. 20)

4. Unzip to allow the window panel to roll down automatically; zip back to close window panel. (Fig. 21 & 22)

NOTE: Repeat steps above for inserting the color matching “spring(s)” into sleeve(s) for the rest of the windows.

Fig. 20	Door	Window Panel
	Window
	Panel
		Sleeves	Fig. 22
		Fig. 21

CAUTION: All “springs” must be removed from sleeves before tearing down tent to avoid damage to the tent fabric or part. To avoid injury, carefully roll up “springs”. Keep out of reach of children. Store rolled “springs in bag with stakes.

Cooler Access

The smaller zippered opening at the back of tent is designed for added ventilation and easy access to your beverage cooler.

1.To use as a vent, unzip flap to expose

screen. (Fig. 23) Fig. 23

2.To use as a cooler access, unzip other flap to make an avenue to bring beverages into tent. (Fig. 24)

Fig. 24

Electrical Cord Access Fig. 25

1.Unzip access panel in the lower right corner of tent and bring in electrical cord. NOTE: Use only UL approved cords rated for outdoor usage. (Fig. 25)

Tent Lighting System

Your tent comes pre-wired with the Coleman® Tent Lighting System. See manual that came with the light and carefully read all instructions before use then save for future reference.

Attaching Room Divider

1.Divider Panel can be installed through center of the tent by inserting toggles through the top and bottom fabric loops as shown. (Fig. 26 & 27)

Divider

Panel

Fig. 26 Fig. 27

To Store

1.All “springs” must be rolled up and placed in bag with stakes.

2.All poles and stakes must be placed in the storage bag to prevent damage to the fabric items placed in the carry case.

3.Make sure tent is clean and dry before placing in carry case.

4.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.

5.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.

6.Store in a clean, dry area.

Things You Should Know:

•Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventila- tion through the tent.

•Tree limbs, tree sap, bird droppings, or moisture steadily dripping off tree limbs can cause damage to the tent fabric and its coating resulting in leaks or loss of flame-resistant properties.

•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•Stakes should be removed by pulling on the stake itself. NEVER PULL ON THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY.

•Tent poles should not be left telescoped together during storage.

•Do not leave your tent set-up for weeks at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material and/or cause it to become discolored.

WARNING: Keep all flame and heat sources away from this tent fabric.

This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

© 2009 The Coleman Company, Inc.

Coleman®, , and are registered trademarks and RockwallTM is a trademark of

The Coleman Company, Inc.

4010004524 (20090515)

STITCH LINE