Coleman 2000001596STITCHLINE To Attach Rainfly, Attaching Room Divider, Cooler Access, To Store

To Attach Rainfly

1.Drape Rainfly over tent. Make sure seams on Rainfly are facing down and centered over poles of the tent. (Fig. 12) NOTE: Hook and loop fasteners, located on seams of under - side of rainfly, should be centered over black and gray poles.

Rainfly

Fig. 12

2.Locate all hook & loop fasteners on underside of rainfly and wrap around each Leg Pole and Window Vent Pole locations.

(Fig. 13)
	Fig. 13

3.Insert metal hook on elastic straps on Rainfly into the hole on each Leg Pole. (Fig 14 & 15)

Center Leg
	Pole	End Leg
Location		Pole
		Location
	Fig. 14	Fig. 15

4.Loop ends of guylines over stakes, stretch tight, then hammer into ground at an angle as shown. (Fig. 16 & 17)

Fig. 16

Fig. 17

Attaching Room Divider

1.Divider Panel can be installed

through center of the tent by
inserting toggles through the
	Top
top and bottom fabric loops as	Fabric
	Loops
shown. (Fig. 18 & 19)
	Divider
	Panel

Fig. 18 Fig. 19

Electrical Cord Access Fig. 20

1.Unzip access panel in the lower left corner of tent and bring in electrical cord.

NOTE: Use only UL approved cords rated for outdoor usage. (Fig. 20)

Cooler Access

The smaller zippered opening at the side of tent is designed for added ventilation and easy access to your beverage cooler.

1. To use as a vent, unzip flap to exposeFig. 21 screen. (Fig. 21)

2.To use as a cooler access, unzip other flap to make an avenue to bring beverages into tent. (Fig. 22)

Fig. 22

Door & Window Flaps/Vents

1.For better ventilation, unzip door flaps, roll, and insert toggle into fabric loop to secure.

2.To open back and side window vents for more ventilation, unzip, then roll up and insert toggles through fabric loops.

To Store

1.All metal poles and stakes must be placed in the storage bag to prevent damage to the fabric items placed in the carry case.

2.Make sure tent is clean and dry before placing in carry case.

3.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.

4.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.

5.Store in a clean, dry area.

Things You Should Know:

•Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventila- tion through the tent.

•Tree limbs, tree sap, bird droppings, or moisture steadily dripping off tree limbs can cause damage to the tent fabric and its coating resulting in leaks or loss of flame-resistant properties.

•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•Stakes should be removed by pulling on the stake itself. NEVER PULL ON THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY.

•Tent poles should not be left telescoped together during storage.

•Do not leave your tent set-up for weeks at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material and/or cause it to become discolored.

WARNING: Keep all flame and heat sources away from this tent fabric.

This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

© 2008 The Coleman Company, Inc.

Coleman®, , , and Weathermaster® are registered trademarks of

The Coleman Company, Inc.

4010004004 (20081113)

STITCH LINE