Assembly Instructions for the Hex Screen House:
You can usually assemble this screen house alone. However, with first time
Component List:
1 Screen/Body w/ Hub 1 Tent Bag 1 Pole Bag 6 Rafters 6 Poles 1 Stake Bag and Stakes
Layout the Parts
•Unpack the tent bag, pole bag and separate all of the components. Choose a suitable place and unroll and unfold the fabric with the Eureka! label up.
•Assemble all of the
Important: Locate the hub fitting attached to the center of the tent roof. Align the hub arms to match the layout of the corner pins without twisting the fabric. See fig.1.
fig.1
fig.2
Fit the Rafters |
|
• Slide a rafter section labeled |
|
"TOP" onto a hub arm.The | fig.3 |
spring clip must engage the |
|
slot in the hub arm. Repeat |
|
with the remaining until all |
|
rafters are secured in place. |
|
See fig.3. |
|
• Make sure the hub and |
|
fabric are still aligned. |
|
Raise the Frame
•Insert the corner ring & pin into the bottom section of a pole.
See fig.4. Then fit the top of the pole into the elbow of its coresponding rafter.
•With a second pole, fit it into the diagonal opposite rafter and pin to form and arch. Lift the arch, and working your way
around the frame, attach the remaining poles to erect a free standing unit.
See fig. 5. fig.4
fig.5
Attach the Fabric to the Frame
•Attach all of the top pole clips first. It may be necessary to open the doors and step inside the shelter to reach the clips. Then, attach all side clips. See fig.6.
•Stake down all corner rings and your Screen House is ready. See fig.7.
fig.6
fig.7
Take down
•Zip the door closed.
•Unstake the screen house.
•Unclip the fabric from the frame.
•Remove the corner pins from the ends of the
poles and remove from the rafters.
•Remove the rafters from the hub. Collapse the sections and store in the pole bag.
• Fold the fabric into thirds. Place the pole bag on the fabric and together, roll them up.
• Pack all components into the storage bag.
www.eurekatent.com
1.800.572.8822
REV E 10.09