Eureka! Tents Grayback manual Assembly Instructions

ASSEMBLY INSTRUCTIONS

GRAYBACK TENT:

Component List:

1 Tent Body, 2 Tent Poles, 1 Carry Bag, 1 Tent Fly, 1 Stake Bag/ Stakes

Unroll and unfold the tent with the floor on the ground. Remove the fly and set it aside. Do not stake the tent down yet. In windy conditions, we recommend that a narrow end should face into the wind and that you stake down one of its corners.

Join the shock-corded poles together. Try to prevent pole sections from snapping together, as this can damage the pole ends. Note: Make certain each insert (male end) has seated firmly into each plain end (female).

At the front corner of the tent A, slide one of the poles through the rod sleeve toward the opposite side of the tent. Push the pole to the opposite corner; A to B. At the other front tent corner C, repeat with the second pole; C to D. See fig. 1 & 2

	fig.2
	fig.1
D	B

C

A

With the poles threaded through their proper
sleeves, start again at the front of the tent and
insert the pin into the pole ferrule at A, making
sure the buckle remains on top of the web.
Walk to B and grasp the other end of the pole
in one hand and the web loop
in the other. Push the pole
from B to A creating an arc.
Insert the pin into the pole
ferrule to tension the tent
across the seam line. Repeat
with the other pole; C to D.	fig.3
See fig. 3 & 4.

fig.4

Working your way around the tent, attach the four clips to the poles.

Your tent is now free-standing, place it in location that has enough room for the fly and stake it down through the rings. Stake the opposite corners while applying tension to smooth the floor wrinkles. See fig. 5 & 6.

fig.5

fig.6

With the tent secure, drape the fly over the tent body. The fly only fits on the tent one way. Position the fly over the tent with the Eureka! logos over the doors. Reach under the fly, wrap the Velcro™ tabs about half way down and around each pole. See fig. 7 & 8.

Connect the four corner buckles on the fly to their mates on the tent webs.

At the front of the tent, pull the vestibule taut and stake down the loop. Make sure that the vestibule is tight across the front of the tent. Repeat with the vestibule at the rear of the tent. Then stake out the two side loops to keep the fly out and away from the tent. Adjust and tighten all the buckles. See fig. 9 & 10.

Your tent is now ready for use.

Take down: Pull up stakes and open doors. Remove the fly. Un-clip tent from the poles.

Pull poles out off the pins, collapse the poles and stow in the bag. Fold the tent/fly. Roll up

both towards the door and stow in the carry bag.

fig.8

fig.7

fig.9

REV.B 4.09 fig.10