Cod. G522433
© Copyright 2009, Alliance Laundry System LLC – DO NOT COPY OR TRANSMIT Rev. 00/0510
Tilt system assembly 34
Lift the washer and remove the crating (refer to
chapter 2 about machine's transport).
Place the machine on wooden pieces (B/fig. 30) so
the four supporting bases stay free and separated
from the floor: value A: 8 inch (200mm) minimum.
This clearance will permit the tilt hinges assembly.
fig. 30
Figure 31 shows a front view of the machine's front
right support
Connect each of the four hinges A to each of the
machine supports B. The four hinges are identical.
Mounting screws D M14x55.
When assembling, each wheel's shaft C remains in
cross position.
Take special care in aligning the hinges edges with
machine supports edges.
If machine needs being levelled to compensate the
floor irregularities, install the levelling supplement
parts E between the hinge and the machine
support.
fig. 31
5.4. Hold down base securing (figure 32) The arrow indicates the front of the machine.
Place the holding down bases A and B on the floor
where the machine is to be installed. The holdi ng
down bases are equal two against two and are
matched in X form. To determine each of the four
bases position, take as a reference the tilt guards
supports C.
Once the machine is placed on these four bases,
without moving it, drill holes in the bases for hold-
down metallic studs; three per base. Metallic studs
external diameter; 17mm. The holes must be
perpendicular to the floor.
Replace the metallic studs washers by the furnished
washers: 13 x 34mm. Secure the bases to the floor
with the metallic studs.
fig. 32