Alliance Laundry Systems SVN255P, UVN255P

Cod. G522433

Installation 20

DO NOT CONNECT THE HOT WATER TO INLET 1. THIS INLET DOES NOT HAVE A TEMPERATURE

CONTROL SYSTEM.

DO NOT CONNECT THE HOT WATER TO INLET 3 IF IT IS NOT CONFIGURED AS A DUAL HOT WATER

INLET FLOW.

INCOMPLIANCE OF THIS PRECAUTION CAN CAUSE FABRIC DAMAGE.

If there is no hot water supply, connect cold water or cold softened water to inlet 2.

ADAPT THE WASHER CONFIGURATION to operating with cold water.

fig. 15

Contents

Main for washers UVN255P / SVN255P IMPORTANT SAFETY INSTRUCTIONS Page HAZARD SYMBOLS USED ON WASHER LABELS: SYMBOLS USED IN THIS MANUAL IMPORTANT INSTRUCTIONS FOR USE AND CONSERVATION I n d e x Page 1.3. Installation Specifications General specifications Page Page 1.4. Electrical requirements E Page Page Page Page Page Page 3. INSTALLATION 3.1. Drain Page Page Page Page Page Page 3.5. Compressed air connection 3.6. External dosing Page Page 3.6.2. Connection order of the dosing signals Page Page T i l t m o d e l s 4. TILT MODELS 4.1. TILT models specific safety instructions 4.2. TILT system description T i l t m o d e l s Page 5.3. Tilt hinge assembly 5.4. Hold down base securing (figure 32) 5.5. Pneumatic actuators assembly (figure 33) 5.6. Position detectors assembly and adjustment (figure 43). 5.7. Assembling Tilt system guards (figure 45)