Alliance Laundry Systems SVN255P, UVN255P

Cod. G522433

Installation 22

Safety switch. Install an Automatic on/off Switch, outside the washer, with individual protection for each

machine.

Characteristics:

 number of poles and intensity: refer to ELECTRICAL CONNECTION table (section 1.6)

 C type with top opening at 0.12 inch. 3 mm

 must isolate electrical source phases and the N cable

 mechanically lockable

 installed in an easily accessible place

ATTENTION!

In machines with ETL mark, the SAFETY SWITCH must be UL489 approved.

3.3.3. Machine electrical connection

 Disconnect and mechanically lock the external automatic switch.

FOR A CORRECT CONNECTION, FOLLOW THE INDICATIONS OF THE TABLE BELOW

 Disconnect and mechanically lock the external automatic switch.

 Open machine terminal box at the rear panel. Remove the support cover of the entry switch to the washer.

 On the entry hole of the electrical supply (Eidentified in figure 2) install a lock mechanism (not supplied with

the washer) to fasten the cable or cable pipe protector, depending on the cable and pipe protector used.

Refer to dimensions and connection diameter in I NSTALLATION SPECS, section 1.4.

LABEL SUPPLY

FEEDING CONNECTION

 Connect the wires directly to the switch

breaker.

 The wire connection sequence to the main

switch varies according to the machine

connection and the power supply. This

connection is indicated on the label posted

next to the main switch.

PE/GND