Cod. G522433
© Copyright 2009, Alliance Laundry System LLC – DO NOT COPY OR TRANSMIT Rev. 00/0510
Installation 29
3.6.3. External dosing hoses connection
The washer is supplied with a manifold with (A, fig. 25):
8 inlets with an outside diameter of 3/8 inch (10mm).
1 inlet with an outside diameter of 1/2 inch (12mm).
Check dimensions of the dosing inlets in INSTALLATION
SPECIFICATIONS, section 1.4.
To connect the product hoses:
Locate the dosing inlets in the back of the machine.
Remove the tube caps and save them.
Connect the hoses to the nipples of the manifold.
Fasten the dosing hoses to the washing machine with the
appropriate clamps.
TILT MODELS
Electrical conductors must be flexible and capable of
accommodating the washer movements during the loading
and unloading operations and secured at their ends.
fig. 25
ATTENTION!
To prevent undiluted chemical dripping inside the washer, all
chemical supply dispensing pumps (fig. 26/A) and all dispenser
tubing (fig. 26/B) must be mounted below the dosing injection
point (fig.26/C) to the washer. Loops do not prevent drips.
Failure to follow these instructions could dam age to was her and
void the warranty.
fig 26