Alliance Laundry Systems SVN255P, UVN255P

Cod. G522433

Transportation and location 15

fig. 7

2.4. Installing more than one washer

If the installation calls for more than one washer, align them with each other.

The minimum distance between adjacent machines and the areas of use and maintenance (values I, S and T

of fig. 7) are specified on the attached table.

Check the dimensions of the drain box and the drain pipe on the table below.

Location specifications (fig. 7)

I DISTANCE BETWEEN MACHINES (MINIMUM) mm (inch.) 700 (27.6)

S WORKING AREA mm (inch.) 1000 (39.4)

T REAR MAINTENANCE AREA mm

(inch.) 750 (29.5)

A DRAIN BOX mm

(inch.) 400 x 400 x 300 (H)

(16 x 16 x 12 H)

 DRAIN PIPE

(x1; x2; x3)  mm

 (inch.) 180; 250; 360

(7; 10; 14)

Contents

Main for washers UVN255P / SVN255P IMPORTANT SAFETY INSTRUCTIONS Page HAZARD SYMBOLS USED ON WASHER LABELS: SYMBOLS USED IN THIS MANUAL IMPORTANT INSTRUCTIONS FOR USE AND CONSERVATION I n d e x Page 1.3. Installation Specifications General specifications Page Page 1.4. Electrical requirements E Page Page Page Page Page Page 3. INSTALLATION 3.1. Drain Page Page Page Page Page Page 3.5. Compressed air connection 3.6. External dosing Page Page 3.6.2. Connection order of the dosing signals Page Page T i l t m o d e l s 4. TILT MODELS 4.1. TILT models specific safety instructions 4.2. TILT system description T i l t m o d e l s Page 5.3. Tilt hinge assembly 5.4. Hold down base securing (figure 32) 5.5. Pneumatic actuators assembly (figure 33) 5.6. Position detectors assembly and adjustment (figure 43). 5.7. Assembling Tilt system guards (figure 45)