JVC MX-K350V manual Setting the REC Recording Timer, Turning the Daily Timer On and Off

Page 29

 

Using the Timers

Preparation for each music source:

Turning the Daily Timer On and Off

Perform the following operation according to the music source

Once you have set the Daily Timer, it is stored in memory. So, the

you have selected. Then, the System enters Volume Setting

Daily Timer will be activated at the same time every day until it is

mode.

canceled.

When selecting TUNER FM or TUNER AM:

 

English

Press the 4 or ¢ button to select the preset station number, then press the SET button.

When selecting 1CD – 001:

1.Press the 4 or ¢ button to select the disc number, then press the SET button.

Each time you press the button the disc number changes as follows:

1CD – 001= 2CD – 001 = 3CD – 001 = (back to the be- ginning)

2.Press the 4or ¢ button to select the track number, then press the SET button.

To cancel the Daily Timer temporarily:

1 Press the CLOCK/TIMER button on the Unit repeatedly until the “DAILY” appears on the display.

2 Press the CANCEL button on the Unit.

The “DAILY” indicator goes out and “OFF” appears on the display.

The Timer indicator ( ) and “DAILY” indicator go out and the Daily Timer is canceled temporarily.

When selecting TAPE:

To activate the cancelled Daily Timer:

Before turning off the system, select either the Deck A or Deck

1 Press the CLOCK/TIMER button on the Unit

B. (See page 20)

When selecting AUX:

repeatedly until the “DAILY” appears on the

Prepare the external equipment so that it will turn on at the ON

display.

time set by the System.

The “DAILY” indicator blinks and the Timer indicator ( )

To allow this, the equipment should have the timer function.

lights up on the display.

6 Setting the volume level.

2 Press the SET button on the Unit.

Press the 4 or ¢ button to select the volume level.

VOL – – – : The current volume level will be used.

The “DAILY” indicator remains lit. Each setting already made

VOL-5,-10, or -15: When the timer is turned on, the Volume

appears on the display in the order of ON time, OFF time, mu-

will be automatically set to the selected level.

sic source and volume, and then the display returns to the orig-

 

inal display.

DAILY

7 Press the SET button.

The timer setting is completed, and the “DAILY” indicator stops blinking and remains lit. Each setting you have made ap- pears on the display in the order of ON time, OFF time, music source and volume. Then, the display returns to the display be- fore you set the Timer.

8 Press the % STANDBY/ON button to turn off the System.

The Timer indicator ( ) and “DAILY” indicator are lit on the display, showing that the Daily Timer is set to on.

To change the timer setting, repeat the setting procedure from the beginning.

When the timer ON-time comes:

The following operation will be automatically repeated every day.

•When the timer ON-time comes, and the System automatically turns on. The music source you have set is played. The Timer indicator ( ) blinks during timer operation.

•When the timer OFF-time comes, “OFF” blinks on the display just before the OFF-time and the System automatically turns off. Then, the Timer indicator ( ) remains lit on the display.

•If the System is already on when the timer ON-time comes, the Daily Timer does not work.

CAUTION:

•If the System is unplugged, or a power failure oc- curs, the timer setting loses its setting immedi- ately. You will need to reset the clock first, then the timer.

Setting the REC (Recording) Timer

With the Recording Timer, you can make a tape of a radio broad- cast automatically whether or not you are home.

•You can set the REC Timer whether the System is on or off.

•Perform each setting within 30 seconds. Otherwise, set- ting will be cleared and the procedure must be repeated from the beginning.

•If you have made a mistake while setting the timer, press the CANCEL button on the Unit. However, this does not al- ways cancel the current setting. If the CANCEL button does not work, press the CLOCK/TIMER button on the Unit repeatedly until the display returns to the original dis- play, and start from the first step.

26

Page 28 Page 30
Image 29
Page 28 Page 30
Contents MX-K350V Important for Laser Products Front view How This Manual Is Organized FeaturesIntroduction Table of Contents Set the Voltage Selector Switch AccessoriesHow To Put Batteries In the Remote Control Getting StartedConnecting the FM Antenna Using the Remote ControlUsing the Supplied Wire Antenna Using an FM 75-Ohm Antenna Cable not SuppliedConnecting the Speakers Connecting the AM AntennaRear Panel of the Unit Right side rear viewConnecting External Equipment Connecting a TVConnecting to the Wall Outlet Demo ModeBasic Operations Turning the Power On and OffAdjusting the Volume Selecting the Sound Mode Entering the Number with the Remote Control Numeric KeysOn the Remote Control Fade-out Muting Fade MutingTuning In a Station Using the TunerSetting the AM Tuner Interval Spacing One Touch RadioTo Change the FM Reception Mode Presetting StationsUsing the Unit Select a station using one of the following methodsDisc Number indicator Lights all the time About the Disc IndicatorPlay mode Repeat indicator indicator CD OpenOne Touch Play To Load CDsTo Unload CDs Programming the Playing Order of the Tracks Basics of Using the CD Player- Normal PlayTo Exit and Re-enter Program Play Random PlayTo Play the Program You Have Made MP3 Discs Playback Repeating TracksTray Lock Function Setting the TV System Using the Video CD Player Video CDsPress the MPX button on the Remote Control Selecting the Audio ChannelPlaying Video CDs with PBC Function VCD What is the Playback Control PBC function?Insert a video CD Press the CD 6 buttonVarious Functions to Enhance Your Enjoyment Playing Video CDs without the PBC FunctionFrame-by-Frame Playback Press the CD 6button to play the video CDViewing the Video Intro of Video CDs Display the TimeViewing the Highlights of Video CDs Changing the Musical Key LevelTo Fast-Wind a Tape Playing a TapeClose the cassette holder gently Press the Tape 3 buttonThings To Know Before You Start Recording Using the Cassette Deck RecordingTape to Tape Recording DUB- Bing Standard RecordingCD Synchro Recording To Record Any Sound Source to Tape Listening to the External Equipment Using an External EquipmentPress the CLOCK/TIMER button Setting the ClockREC Recording Timer Sleep indicator Daily Timer indicatorSetting the OFF time Example Setting the Daily TimerSetting the on time Example Selecting the music sourceTurning the Daily Timer On and Off Setting the REC Recording TimerSetting the on time you want the System to turn on Turning the REC Recording Timer On and OffSetting the OFF time you want the System to turn off Select the preset station for recordingTimer Priority Setting the Sleep TimerDuring playback a source, press the Sleep button Wait for 5 secondsVolume level, etc Using the MicrophoneKaraoke indicator Echo indicator Singing Along with KaraokeMicrophone Mixing Playing the Microphone SoundThrough the Speakers Care And Maintenance Specifications TroubleshootingImportant for mains AC line
Top Page Image Contents