Battery Installation

The Receiver Wrist Monitor uses a CR2032, 3V Lithium battery. When the battery is running low the low-battery indicator will light up. To guarantee the water resistance take the monitor to a local jewelry store for battery replacement. Improper replacement will void the warranty.

The Transmitter uses a CR2032, 3V Lithium battery. If the heart rate signals become unsteady or stop your transmitter battery may need replacing.

To change the Transmitter battery:

1.Open the transmitter battery lid with a coin by turning counterclockwise.

2.Remove the old battery.

3.Insert the new battery with the positive side facing up. DO NOT touch the contacts.

4.Replace the battery lid.

CARING FOR YOUR MONITOR

To keep your heart rate monitor in the best condition and protect the unit from damage follow these directions:

•Clean the monitor with a soft dry cloth. Do not use any abrasive or volatile cleaners.

•Always thoroughly dry off any moisture on the components before storing.

•Store your monitor in the original carrying case.

•Do not subject the monitor to extreme hot or cold temperatures, humidity and direct sunlight.

•Do not excessively twist or bend the conductive pads on the transmitter belt.

•Do not subject the transmitter or receiver to strong shocks, such as dropping on the floor.

•Use the unit consistent with the instruction provided in this manual.