ASSEMBLY INSTRUCTIONS
Strap |
STEP 4
Attach the SEAT(43) to the SEAT POST(4) with NYLOCK NUTS(M8x1.25)(62) and WASHERS(M8)(67). Slide BELLOWS(45) over the SEAT POST(4). Insert the SEAT POST(4) into the MAIN FRAME(1) and lock in position with LOCKING KNOB(46).
STEP 5
Slide the Cable of the TENSION KNOB(27) into the slot on the MONITOR POST(5). Hook the top end of the TENSION KNOB(27) into the square hole on the MONITOR POST(5) and secure with FLAT HEAD SCREW (M5x0.8x15mm)(58).
STEP 6
NOTE: There is a strap attached inside of the MONITOR POST(5). This strap is to assist in pulling the SPEED PICKUP WIRE(23) through the MONITOR POST(5).
Tie the strap to the plug end of the SPEED PICKUP WIRE(23). Pull the strap from the top of the MONITOR POST(5) to pull the SPEED PICKUP WIRE(23) through the MONITOR POST(5) as shown in the above illustration. The SPEED PICKUP WIRE(23) must extend out the top of the MONITOR POST(5).
Attach the MONITOR POST(5) onto the MAIN FRAME(1) by hooking the front end of the Bracket on the bottom of the MONITOR POST(5) onto the round tube on the MAIN FRAME(1), then secure with the ROUND HEAD SCREW(M5x0.8x6mm)(73) at front of the Bracket. Secure the back end of the Bracket of the MONITOR POST(5) with the ROUND HEAD SCREW(M5x15mm)(53). Remove the strap from the
SPEED PICKUP WIRE(23).
7