Life Fitness Models 9500RHR / 9100R Recumbent Exercise Bike
Fitness Entertainment Kit Installation (Continued)
Step 12
Apply a CABLE CLAMP to the user front of the MONOCOLUMN approximately 6” up from the top of the COLLAR. Apply a second CABLE CLAMP to the user front of the MONOCOLUMN approximately 1” down from the DISPLAY CONSOLE BRACKET. Continue routing the FITNESS ENTERTAINMENT CABLE ASSEMBLY upwards flat against the COLLAR and MONOCOLUMN and insert the FITNESS ENTERTAINMENT CABLE ASSEMBLY into the CABLE CLAMPS.
Step 13 (Cardio Theater Wireless System Only)
NOTE: WITH A SUPPLIED ALCOHOL WIPE, CLEAN THE SHROUD AT EACH HOOK AND LOOP FASTENING STRIP LOCATION BEFORE MOUNTING THE HOOK AND LOOP FASTENING STRIPS.
Remove the four screws and mounting block from the back of the FITNESS ENTERTAINMENT RECEIVER. Remove the backing on one side the hook and loop fastening strips provided and apply lengthwise to the back of the FITNESS ENTERTAINMENT RECEIVER. Remove the backing of the remaining side of the hook and loop fastening strips and apply the FITNESS ENTERTAINMENT RECEIVER to the underside of the DISPLAY CONSOLE as shown. Press firmly to ensure proper adhesion.
Step 14 (Cardio Theater Wireless System Only)
Receiver
Display Console
Display Console
Bracket
Cable Clamps
Monocolumn
Cable
Assembly
Collar
Plug the FITNESS ENTERTAINMENT CABLE ASSEMBLY and the FITNESS ENTERTAINMENT TOUCHPAD CABLE ASSEMBLY into the appropriate jacks on the FITNESS ENTERTAINMENT RECEIVER.
Step 16
Using two supplied wire ties, mount the FITNESS ENTERTAINMENT TOUCH PAD to the bike. Controller location is at the discretion of the customer. Refer to the CARDIO THEATER or BROADCAST VISION MANUAL for suggested locations.
Step 15
Plug the remaining end of the FITNESS ENTERTAINMENT TOUCHPAD CABLE ASSEMBLY into the FITNESS ENTERTAINMENT TOUCHPAD (Cardio Theater Wireless System). Plug the end of the FITNESS ENTERTAINMENT CABLE ASSEMBLY into the FITNESS ENTERTAINMENT TOUCHPAD.