Around the Pedal and Crank Shaft | Life Fitness 9100 specs

Life Fitness Models 9500RHR / 9100R Recumbent Exercise Bike

Fitness Entertainment Kit Installation

(for use with Broadcast Vision Fitness Cinema and Fitness Cinema 900 and Cardio Theater Wireless and LCS Wireless systems)

Tools Required: Phillips Screwdriver, Small Adjustable Wrench

Step 1

Release the COLLAR by carefully depressing the user left and right sides inward until the COLLAR TABS disengage from the

SHROUDS.

Step 2

Remove the seventeen screws securing the user right SHROUD and carefully remove the SHROUD from the frame.

NOTE: BE CAREFUL NOT TO DAMAGE THE SHROUD WHEN MANEUVERING IT

AROUND THE PEDAL AND CRANK SHAFT.

Step 3

Remove the nuts and washers from the ALTERNATOR TERMINALS “B” and “E”. Place the red wire RING TERMINAL(large) of the FITNESS ENTERTAINMENT CABLE ASSEMBLY over ALTERNATOR TERMINAL “B” and secure the connector with the appropriate nut and washer. Place the orange wire RING TERMINAL of the FITNESS ENTERTAINMENT CABLE ASSEMBLY over ALTERNATOR TERMINAL “E” and secure the RING TERMINAL with the remaining nut and washer. Tighten nuts to 25 - 30 in. lbs.

NOTE: DO NOT REMOVE THE EXISTING RING TERMINALS FROM THE

ALTERNATOR STUDS.

NOTE: TO AVOID POTENTIAL DAMAGE, BE SURE THE RING TERMINALS OF THE FITNESS ENTERTAINMENT CABLE ASSEMBLY FACE THE CENTER OF THE ALTERNATOR.

Step 4

Route the FITNESS ENTERTAINMENT CABLE ASSEMBLY along the existing wire cluster and secure it near the existing wire tie with a supplied wire tie.

NOTE: BE SURE TO LEAVE ADEQUATE STRAIN RELIEF OF THE

FITNESS ENTERTAINMENT CABLE ASSEMBLY AT THE ALTERNATOR.

Step 5

Cable Assembly (Bundle Excess)

Terminal “B”

Terminal “E”

Cable Tie

User Right

Bottom Frame

Member

Figure 3

Route the FITNESS ENTERTAINMENT CABLE ASSEMBLY along the top of the USER RIGHT BOTTOM FRAME MEMBER and secure with a supplied wire tie next to each existing wire tie location. (Figure 3)

Collar

1”

Cable Clamp

User Left

Shroud

Cable

Assembly

Step 9	Figure 4

Step 6
Feed the FITNESS ENTERTAINMENT	Terminal “B”
CABLE ASSEMBLY out the bottom of the
bike behind the FRONT SHROUD	Terminal “E”
BRACKET.

Step 7

NOTE: WITH A SUPPLIED ALCOHOL WIPE, CLEAN THE SHROUD AT EACH CABLE

CLAMP LOCATION BEFORE MOUNTING THE CABLE CLAMPS.

Place one ADHESIVE BACKED CABLE CLAMP 1” down from the top ridge of the user left shroud and 1/2” from the inner edge. Position the CABLE CLAMP with the opening facing the inner edge of the user left shroud. (Figure 4)

Step 8

Place another ADHESIVE BACKED CABLE CLAMP at the bottom front edge of the user left shroud. Position the clamp with the opening facing the outside of the bike.

Place a third CABLE CLAMP on the underside of the user left shroud front as close to the frame as possible (approximately 1” from the frame). Continue to route the FITNESS ENTERTAINMENT CABLE ASSEMBLY tight against the user left shroud inserting the FITNESS ENTERTAINMENT CABLE ASSEMBLY into the three pre-attached cable clamps.

Step 10

Apply four CABLE CLAMPS to the front of the user left shroud in-line and between the two previously installed CABLE CLAMPS alternating the direction of the cable clamp openings. Insert the FITNESS ENTERTAINMENT CABLE ASSEMBLY into the CABLE CLAMPS.

Step 11

Reverse steps 1 and 3 to return all shroud parts to their proper positions. Tighten screws to 12 - 15 in. lbs.

Continued