Blade assembly RS 10, RL 10 (Fig. F)
Remove the Accu from the working unit!
Disassembly
Release both screws (F6) and remove the complete blade set by slightly tilting as you remove it.
Assembly
The upper blade must be placed exactly in the middle of the lower blade. Turn the cam gear (F1) so that the marking line (F2) is pointing exactly forwards.
Firstly guide the blade underneath the blade peg of the sliding sled (F3). Make sure that the cam (F4) snaps into the connecting link (F5). Tighten screws. (F6).
Blade assembly RL 20 (Fig. F/G)
For the Grass Cutter you
need two sets of Spare Blades, Art. No. 2346. Please always replace both sets of blades at the same time. This avoids pos- sible imbalance during operation and prevents damage.
Disassembly
Release the four screws (G3). Remove the sled (G1) and the com- plete cutting blade set by slightly tilting it as you remove it.
Assembly
The upper blade must be situated exactly in the middle of the corre- sponding lower blade. Turn the cam gear (F1) so that the marking line (F2) is pointing exactly forwards. Firstly guide each blade underneath the blade peg of the sled (G2). Make sure the cam (F4) snaps into the connecting link (F5). Insert the
sled (G1). Make sure that the guiding groove fits securely over the two middle blade ends. Tighten screws (G3).
Please note: Before inserting new blades, clean the gear area.
Lubricate the gears with some noncorrosive grease (Vaseline).
Hold the Grass Shears in correct working position before the Accu is clicked in and the unit is switched on again.
The blades should always be sharp in order to obtain good cutting results. They can be sharpened by using a sharpening stone. We especially recommend immediate removal of notches and burrs which could be caused by stones. The opportunity to separate the upper and lower blades makes sharpening especially easy.
With problems, please contact
one of our Service Centres or send the defective unit together with
a short description of the problem and, in case of guarantee, with
a copy of the receipt directly to one of our Service Centres.
We expressly point out that,
in accordance with the product liability law, we are not liable for any damage caused by our units if, in the case of repair
or exchange, original GARDENA spare parts are not used and repair is not carried out by a GARDENA service centre or an authorised specialist. The same also applies to spare parts and accessories.
16
