2.Attach the Left and Right Frame Covers (36, 37) around the Frame (1) with four M4 x 16mm Round Head Screws (80).
3.With the help of another person, carefully tip the elliptical exerciser onto its side. Attach the Center Foot (40) to the Frame (1) with two
M4 x 16mm Screws (78). Then, return the ellipti- cal exerciser to the upright position.
Orient the Rear Stabilizer (3) as shown. While another person lifts the Folding Frame (2), attach the Rear Stabilizer to the Folding Frame with two M10 x 80mm Button Screws (93) and two M10 Split Washers (99).
4. While another person holds the Upright (10) | ||
near the | Frame (1), connect the | Upper Wire |
Harness | (65) to the Lower Wire | Harness (64). |
Then, insert the Upright (10) into the Frame (1). | ||
Attach the Upright with four M8 x 19mm Button | ||
Screws (85) and four M8 Split Washers (97). Do | ||
not tighten the Button Screws yet, | ||
/,
37
,80
80 36
78
3 9993
Avoid pinching the
Wire Harnesses (64, 65)
Avoid pinching the Wire Harnesses (64, 65) |
during this step. |
", "i
_Jl0 ' i
i "I i, 97
65-_i/
during this step
85
97.97
85
97 ',
6