PYLE Audio PFEVEX19010 user manual Two M10 Black Nylon Locknuts, Touching the floor, Harnesses

1.Identify the Front Stabiliser (2), which has Wheels (30) on the ends. Whilst another person lifts the front of the Frame (1) slightly, attach the Front Stabiliser to the Frame with two M10 x 112mm Carriage Bolts (65) and

two M10 Black Nylon Locknuts (63).	Make sure that
the Front Stabiliser is turned so the Wheels are not
touching the floor.

2.Whilst another person lifts the back of the Frame (1) slightly, attach the Rear Stabiliser (3) to the Frame with two M10 x 112mm Carriage Bolts (65) and two M10 Black Nylon Locknuts (63).

3.Whilst another person holds the Upright (13) in the position shown, connect the Upper Wire Harness (36)

to the Lower Wire Harness (35). Carefully pull the

upper end of the Upper Wire Harness to remove any slack from the Wire Harnesses; make sure the connectors do not catch on the indicated rod.

Turn the indicated Adjustment Knob (28) counterclock- wise two or three turns to loosen it. Next, pull the Knob, insert the Upright (13) into the Frame (1), and then

release the Knob.	Be careful to avoid pinching the
Wire Harnesses (35, 36). Move the Upright up and
down slightly until the pin on the Knob snaps into
one of the holes in the Upright.		Then, turn the Knob
clockwise until it is tight.

Tighten the M6 x 25.4mm Button Screw (33 into the

Frame (1) and into the slot in the side of the Upright (13).

4.The Console (16) requires four 1,5 v (“D”) batteries (not included); alkaline batteries are recommended.

Press the tab on the battery cover, and lift off the bat- tery cover. Insert four batteries into the battery com- partment. Make sure that the batteries are oriented

as shown by the diagram inside the battery com-

partment. Reattach the battery cover.

1	30
65
30
2
	1
	63
2	63
	3
63
1
	65
3
	Be careful to avoid
	pinching the Wire
13	Harnesses.
Rod
Slot
	1
36	28
35
33
4	Tab
Battery
Cover
Batteries
	16

6